what is the difference between megger and earth tester?
- 28 Answers
- 97642 Views
- Ashok Leyland, IOCL, RRL, I also Faced
- E-Mail Answers
Answer Posted / shahid
megger is trade name of instrument and used for IR value and
earth tester is used for test the ground conductor
resistance if u see all same but earth tester 3 wire.
| Is This Answer Correct ? | 2 Yes | 1 No |
Post New Answer View All Answers
for 100 HP Induction motor service factor is 1.2(SF) we placed a VFD at the motor side load is balance with 0.3 Amp's Phase to Phase but at incoming of VFD load is un-balance with 10 to 20 Amp's what will be cause of load un balance
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
What is the height of DA, DAL, DB, DC & DDE tower?
What is the formula to calculate a three phase alternator
The knee point of a current transformer is normally unique and known.So why in the nameplate of a CT they put the minimum value like this Vk> 400v.
How to Decide(calculate) Bush bar size for copper and aluminiam ?
What happen if we apply square wave or traiangular waveform voltage to the transformer primary winding instead of sinusoidal wave?
Describe the test procedure to determine the vector group
I have done my m.tech in electrical engg discipline. Can any one please suggest me how should I prepare for getting into phd in iit or nit.How should I prepare for getting into lecturership
why we testing the core balance of the transformer before comissioning?
Refernce currents are to be generated using refernce cueernts how can this be done
what are the steps involved in generator load test?
what is subtransient , transient and steady stateac components
the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?
Let me know that how i calculate the alternator sub tranciant reactance and tranciant reactance.
