Answer / ankaraju.k

The generator in hydroelectric power plant is has low
speed,so the number of poles is high,so diameter is high.so
you placing Vertical position is good to save place.

Answer / rajesh tokalapudi

generators in hydro plants r of salient ploe type.salient
pole generators r having high diameter and less axial
lengh.as a matter of space it is placed vertically over the
hydro turbine to save the place.

Answer / s s

vertically,as water turbine is placed below this which is
rotated by the water thu dam.

Answer / anbuselvan

Yes, It will be positioned in Vertical manner.

Bcaz,the of saves the place such a way that v can adopt many
generator by many Pen-stock pipe, which carries the Water
from dam into its generator Turbine.

Answer / guruvendrakumar

vertically.so save the place

Answer / amar

Vertically/ Flange-mounted over the Turbine..

Answer / pavan

Co-axisially

Answer / kumar

normally

Answer / ankaraju.k

centrifugal forces are less

Answer / ankaraju.k

Horizontally

What is the difference between a Junction Box and a Marshalling Box?

8 Answers  

should dc supply will give the transformer to build up the voltage level

1 Answers  

Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?

0 Answers  

Will any motor burn if voltage provided is lesser than the rated voltage???? If yes, then how is speed control possible with voltage control

0 Answers  

I have a reading off 1.5ohms at my mem my main c/b is rated at 40/6 amps in a domestic house and i was told to change it to a b curve c/b is this ok

0 Answers  

how to check the LRS resistance .......................

1 Answers  

Brief difference btween aluminium & copper conductor

2 Answers  

HOW WE CHOOSE EARTH'S POTENTIAL AS ZERO V?

0 Answers  

Why and when NGR panel required. Is it necessary to design a NGR panel for a 6.6kV Alternator paralleling with Grid????

0 Answers  

how many kw = one ton air condition?

2 Answers  

i want to know about for what reason we are using star delta starter? how it works? what are the advantages?

4 Answers  

how we calculate fault current& load factor or fault level&also the leakage current

1 Answers