Interested to Buy Any Domain ? << Click Here >> for more details...
How a generator is positioned in a hydroelectric power
plant?
- 10 Answers
- 24209 Views
- Infosys, I also Faced
- E-Mail Answers
Answer Posted / ankaraju.k
The generator in hydroelectric power plant is has low
speed,so the number of poles is high,so diameter is high.so
you placing Vertical position is good to save place.
| Is This Answer Correct ? | 34 Yes | 4 No |
Post New Answer View All Answers
Explain about technical and non technical losses in distribution system?
What will be in Mahagenco Trade Test Exam? I want to know the same.
What is dc current source?
My question is whether bellow formula is correct to find bus size for 46kA for 0.5 second & what is RT in bellow formula. formula to calculate the size of busbar to withstand the thermal stresses due to currents with duration of 0.2 sec to 5 sec. Sp = RT( I x I x t) / K Where Sp – is the cross sectional area of bus bar in millimeters. I - is the value of AC fault current. t - is the operating time of disconnecting device in seconds. K – is the factor depending on the material of the conductor, insulation and initial and final temperature. Value of ‘k’ for copper is 143.
what is the reason for indication of light in the earth lamps of main switchboard.if there is an earth why does one lamp get dim and the other two bright.
What is load boxes ?
State thevenintheorem?
Why electrical power generation and transmission done in 3 phase system not more than 3 phase ?
i am going to give the JSEB,RANCHI exam for power plant,so i need some samples of papers related to that,so please send me these papers by my mail id.
3 shows a 415 V, 3-phase generator supplying a 3-phase 415/110 V transformer. Draw the individual and combined impedance diagrams to a base of 10 kVA. Determine the system fault kVA and the fault currents at the 415 V and 110 V busbars for short circuit faults on the transformer input or output terminals. Work in p.u. values of impedances.
What is the need for a controller?
I am about to write exam in RRB bangalore for the post of section engineer.please provide me with previous exam questions
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
What is the difference between PS & metering CT (5p20,0.5 etc.)? Why in PS class CT only Vk is given ? Is PS class CT is more accurate than metering CT?
Why power factor should not be in leading (capacitive) mode of any load.
