Interested to Buy Any Domain ? << Click Here >> for more details...
How a generator is positioned in a hydroelectric power
plant?
- 10 Answers
- 24094 Views
- Infosys, I also Faced
- E-Mail Answers
Answer Posted / ankaraju.k
centrifugal forces are less
| Is This Answer Correct ? | 2 Yes | 10 No |
Post New Answer View All Answers
how the CT and PT is connected in the circuit during testing of transformer explain with diagram
what are the installation procedure of high voltage power transformer,CT,CB&PT?
Which standard we are following earthing resistance test
I just purchased a 4 position cam switch to be used to operate a 3-speed blower motor. The motor is a 10 amp motor and has 3 wires that are used to control speed. The cam switch was rated at 660V 20 amps but when I received it, I noticed that it has AC-15 operational current rating (Ie) of 4/5 amps. If I am reading the label correctly. the 4/5 amps is related to 440v/220V (Ue). Other ratings are AC-3: 5.5A, AC2: 7.5A and AC-4: 1.5A. My questions are 1) Is it safe to use this switch with the motor I have 2) what is the difference between the 20 amp Ith ratting and the Ie operational ratings?
how to calculate
Why ground terminal is used in pot meter 10k ohms
Explain what is clipper and clamper circuits?
How 3 phase invertor works?
What is voltage divider rule?
If there are two transformer having rating of 2.5mva, 6.6kv/440v(satr-star),and the load is 600kw then what is better to maintain less losses in transformer having both transformer in parellel or only single transformer connected to load? Please give calculated answer
What are the advantages of vscf wind electrical system?
IF 8255 CONTROL WORD IS 94H,Tell the chip port work mode ?
What is the approximate value of stacking factor?
how we test a 3 phase motor on single phase supply....? HOW WE RUN A 3 PHASE MOTOR ON SNIGLE PHASE. supply for testing..? how we verify of a 3 phase motors 6 wire & name thame a1/a2/a3..b1/b2/b3 and c1/c2/c3 for connecting star delta starter ........i have only 1 phase supply ? help forum..........
How can we decide cable size from HT panel to Transformer? Please give you reply with some examples.
