How a generator is positioned in a hydroelectric power
plant?
Answer Posted / guruvendrakumar
vertically.so save the place
| Is This Answer Correct ? | 5 Yes | 0 No |
Post New Answer View All Answers
An ELHNC 80amp 240v 30mA RCD is tripping periodically, every 30 - 180 seconds is it safe to disconnect the protection circuit?
in control panel, how can i measuring the distance between one bus bar to another bus bar. then now only for bus bar. in mpcb and contactor also. that means one mpcb to another mpcb how much distance? how can i calculate that.
How to calculate cable size by using load.?? Any formula...
How to discuss the phase shift of transformer considering open delta?
why is using sensor?what is differece between photoelectric and proxmitty?
what is breathing?
How do you calculate the actual power consumption of an inductive load appliance. Say, a deep freezer of 200watts
What is signal flow graph?
Is there any type of starter for DC motor other than two point,Three point and Four point starters?
hi pal, i am vengatesh from tamilnadu(chidambaram),i have called for the written test for the post of jr executive(ELECTRICAL) of AAI ,I dont know about the question paper pattern,so any kindly help me to face the examination,post me the model question papers and some tips to write my examination to (vengi.annadurai@gmail.com)
difference between a diode and thyristor?
what happen if the parallel generator phase angle shift by 1 degree in manual mode
if 2 coil of 1000W connect in series and 200 v is applied across it . then what is the total power of coil when coil have only resistive load .
In the ACB breaker capacity is 2000Amp but this each phase taken 1250 But total beldibg load is 600amp or 700amp watt is the problem
How efficiency of thermal plant can be improved?