What is instrumentation measurement?
No Answer is Posted For this Question
Be the First to Post Answer
Steve said that "An eddy-current probe works by passing an alternating current through a coil of wire and measuring the coil’s impedance" while we are using -24 Volt DC , So I am confused about DC and AC. Plz .
2 Answers Jindal, Sadara Chemicals,
State bernoulli’s application.
What is live zero and dead zero
I HAVE PRESSURE TRANSMITTER WITH TWO WIRES 24 VOLTS SUPPLY.IF TRANSMITTER WILL GIVE SIGNAL TO THE DCS WHAT HAPPEN TO THE 24 VOLTS POWER SUPPLY IT WILL DROP OR REMAIN TO 24 VOLTS POWER SUPPLY.
What is the Difference between E/P Positioner and I/P positioner in a control valve? In which applications the respective positioners are used in?
how we can check level probe and controller
can you give some devices that measure directly the mass flow rate.
In which principle Woodward Governor 505 work in power plant? What are the input of Woodward governor 505
can we copy the software from a transmitter using hht(hart 275) ?
Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72
how to calibate level transmiter ?range -150 to +150.what is the zero and span?
In dcs panel we are using diff type of modules ?what is module ? what is the use of modules ?diff type of module?