Dear friends, I have a question: We work on a project which has some boilers to provide steam for desalination unit. The boiler area is safe and the only hazard source is the fuel lines of boilers. I want to know according to NFPA standard which type of instrument should be selected on the fuel line: Eex Type or Non-Eex type? Thanks in advance

2 Answers  

---

how can we caliberate interface level troll

2 Answers   Grasim, IOCL, KOC, Sankyu,

---

.how does CSADA systems display the process variable value?

2 Answers   Empower,

---

In split range control, we will control 2 outputs with time interval. Eg :(with 4-20 ma signal, for 4-12 ma we are operating one control instrument like valve & for 12-20ma we are operating other control instrumet (other valve). If we get a signal of 15ma to first instrument (Valve 1), what will happened to the first valve, and if we get signal above 20 ma to 2 valve what will happened ?

3 Answers  

---

what is the difference between signal cable and ontrol cable?

14 Answers   Essar,

---

---

WHAT ARE THE INSTRUMENTAL DIAGRAMSOF VALVES?

0 Answers   Artikal, ITC Infotech,

---

how to overhaul control valves.what are the proper procedures.

1 Answers   Jindal, QAFCO,

---

Good Evening all.My question is - For a feed water line to an equipment if i need to measure the flow we will use orifice /magnetic/vortex depend on cost/spec.If i need to measure a ''Alarm''signal and ''Interlock'' from one point i think we can use orifice type in one location with 2 different tapping points - one for alarm and one for an interlock to flow valve..If in case i need to have both these signals(Alarm & interlock) from magnetic flow meter,is it possible??will 2 seperate sensors will be located inbuilt r we can program it ??..i thk we can have one transmitter with these 2 signals...need to know any technical issues are there?pls clarify

3 Answers  

---

if a dp transmitter has range 100 in H2O and flow is 20mmcf and if the flow is changed to 25 mmcf then what is the formula to determine new range of transmitter

1 Answers   TATA,

---

A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?

0 Answers  

---

what is o2 analyzer and how it measured ,what is the role of this analyzer in cfbc boiler...

2 Answers  

---

Could anybody pls give ans of boiler 3 element control system?

5 Answers   Qatar Petroleums,

---