In a synchronous motor. if start is running at high speed. What will be the starting torque :
Higher
Lower
Zero
No Answer is Posted For this Question
Be the First to Post Answer
HOW TO CONNECT THREE PHASE OVER LOAD RELAY FOR SINGLE PHASE
Is the theorem applicable to ac sources?
WHY KVAR IMPORTANT WHEN ANY PLANT IS RUNNING ON IT'S OWN POWER PLANT?
When we synchronize the Generator BKR with TIE BKR then Gen BKR is hold but TIE BKR is Tripped on Non directional over current but when TIE BKR is Syn. with Gen. BKR then no fault occur so what is the problem
what is the principle to generate energy from water or coal, plz define the step by step how & when electricity energy start from resource area to ours home meter & separate & how meter read the voltage or current?
which capacity of RCCB used for five thousand watt electricity load?
Why the transmission lines are in 11kV, 22kV, 33kv, and why not 10kV,20kV, 30kV?
How Much Capacity of Diesel Genset is suitable for 20 no.s of 1.5ton AC's & Why?(Load Calculation)
11 Answers Lapis Technologies,
What are the advantages of using distance protection schemes as opposed to normal overcurrent/ earth fault protection on high voltage feeders.
funtion of choke
what is form factor?
What is the effect of solar radiation on the design of an Isolated Phase Busduct?
0 Answers Exide, Punj Lloyd Ltd,
Civil Engineering (5086)
Mechanical Engineering (4456)
Electrical Engineering (16639)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)