where this neutral connection goes after returning from the
load(home ,factory,industries).Is it grounded at the
transformer side or atthe generator side .If it is grounded
then we also ground the earth connection.is there any
problem with this.



where this neutral connection goes after returning from the load(home ,factory,industries).Is it g..

Answer / beaconguru@gmail.com

Transformer secondary side neutral is earthed.if unbalanced load condition residual return current only goes to earth it's a safest one actually.In basic ground is the very low impedance path compare to your earth rod.current always choose low resistive path.so it's not possible to return feed current flow from ground to equipment.

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More Electrical Engineering Interview Questions

usually why bettery voltage are 1.5V, even if you open a 9V battery there are six 1.5V batteries in series. is it not possible to increase this voltage other than putting in series

1 Answers  


What is your acheivements

0 Answers  


what is the difference between thyristors and capacitors

2 Answers   DRDO, ETE,


An 8 pole, 50 Hz, 3-phase IM is loaded to a poing where pull out torque will occur. The rotor resistance per phase is 0.3 ohm and motor stalls at 650 rpm. The rotor reactance at stand still is A 2 ohm B 1.25 ohm C 3.15 ohm D 2.25 ohm

0 Answers  


What do you mean by phasors?

0 Answers  






Why transformer used in UPS??

0 Answers   JLL,


What is polarisation index value?.(pi value) Simple & brief definition of polarisation index?..

7 Answers  


mounting of bucholz relay engle on transformer

4 Answers  


True or false question. 1.The fuse provide phase and neutral 2.power loss in electrical circuit can take place in (resistance or inductance or capacitance). 3.two phase system each phase has separated by a phase difference of (90 or 180 or 270 or 45). 4.3 phase balanced star connected load neutral current shall be (line current or phase current or zero or unity)

0 Answers  


Which motor is 3.3 or 11kV more reliable, in terms of efficeancy,maintenance, reliability.

0 Answers   Megatron Solutions, TCL,


the site measured knee point voltage of protection class CTs should be greater than rated knee point voltage? what about meetering class CTs. Should it be below the rated knee point voltage?

0 Answers  


What is burden of a current transformer. What is function of core in Transformer

1 Answers   Jindal Steel and Power, NCC,


Categories
  • Civil Engineering Interview Questions Civil Engineering (5084)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16631)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1094)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)