Answer / puja gope

converter is used to convert ac to dc whereas inverter is used to convert dc to ac.supply used in converter is ac & for inverter supply is dc.

Answer / mani

Converter is converting the AC to DC and this DC is stored in a Battery then the stored DC supply is forwarded to Inverter  to convert the AC Supply . When the AC Supply is failed the battery id feeding the DC Supply to the inverter for providing AC supply up the energy stored in the cell.

why dc supply is not applied for step up or down in transformer

3 Answers  

---

single sphase energy meter measur

7 Answers  

---

what is the difference between H.T Or HV lines...?

1 Answers  

---

Why generally the transformer primary is connected in star & secondary in delta

7 Answers  

---

we have taken HV test of 2.5 k and Megger test on 11 kv HT cable.here it shows no fault but when we are charging the same cable with 11 kv supply why the VCB 11 kv gets tripped can anybody define the possible cause of fault ?

4 Answers   MAHINDRA,

---

why no load voltage is greater than full load voltage?

1 Answers  

---

Define relative stability.

0 Answers  

---

What is the one main difference between ups & inverter ? And electrical engineering & electronics engineering ?

0 Answers  

---

WHAT IS AIR GAP VALUE IN MM FOR A 11KV BUSHING OF 11KV/440V DISTRIBUTION TRANSFORMER. AND AIR GAP VALUE OF 25 KV BUSHING OF AT TRANSFORMER OF 25 KV TRACTION. WHAT IS THE CALCULATION FOR THE AIR GAP PERMITTED FOR BUSHINGS AT DIFFERENT VOLTAGES.

0 Answers  

---

1.Can we use 6.6/11KV 300sq mm xlpe 3core cable for LT use (415 Volt). 2. If we use it for LT then what is the current rating

0 Answers  

---

the single phase voltage is 230 volts and threee phase is 430 v.why three phase is not 660 v?

2 Answers  

---

a induction motar has 30-35% exciting current at no load but in transformer it is only 2-3% ofbrated current why any reason?

1 Answers   century,

---