Answer / k.prakashchandra

It is usually 1

Answer / irfankh

1=1

what is through fault?

0 Answers   KSEB,

---

What are the basic elements used for modeling mechanical rotational system?

0 Answers  

---

Baud rate is used to descrice...?

2 Answers  

---

How can i calculate knee point voltage of 800/5A Current transformer?please explain me with suitable calculation?

2 Answers  

---

Why we use three phase world wide why not four phase or five phase being used?

8 Answers  

---

It is advisable 2 use auto-transformer if transformation ratio is-a)110KV/11KV,b)230kv/110kv,c)110kv/66kv,d) 400kv/230kv

2 Answers  

---

could mail me the question papers for the test.

1 Answers   ONGC,

---

why capacitor rating measure in KVAR. ?

2 Answers  

---

is it possible for different brand of H.V transformers to run or operate in parallel to each other? if so how much disturbance can this affact the H.V bus bar?

0 Answers   Unitech,

---

What Normal(Tangent) towers and Tension(Cut-point) Towers?

1 Answers   ABB, BGR Energy, NTPC, Powermec,

---

why we are using large cross section cable at load side and small at other (11kv to trsfr)side of transformer? when the load increses current at both side increases,right?

2 Answers  

---

How will polarity test of Dy5 Transformer ?

0 Answers  

---