Answer / rajesh.

Reset means to clear the content of register (memory), and initialization means to rebooting the system so that it will again scan the cycle program and become in normal mode.

What is input and output of plc & dcs

2 Answers  

---

Explain the functions of the CPU of a PLC.

1 Answers  

---

In bently nevada vibration monitoring system,what is the reason to maintain the Resistance of the probe + extension cable equal to 95 ohm? If possible explain the basic principle of measurement with detail electronic circuits.

0 Answers   Essar,

---

WHAT IS THIS INSTRUMENTATION?

7 Answers  

---

What is zener diode? What is voltage regulator?

0 Answers  

---

my temperature transmitter in field showing 700 degree , whereas in dcs showing 459 degree, how to resolve this?

4 Answers   ONGC,

---

What should be the main consideration while starting the Rotating compressor when we dont know the cut in and the cut off pressure setting of the pressure switch

0 Answers  

---

which is the best type to measure level of a Tank(water). Displacer or Differential Pressure method?

2 Answers  

---

i want know about capillary type LT transmitter installation. we can install any location in between to HP and LP leg?

2 Answers  

---

why we go for pcbs

2 Answers  

---

What is the formula of vabration sesore. i mean how to covert mils to volt plz share if any body knows   very argent : my mai is merajalam143545@yahoo.com

0 Answers   Samsung,

---

use of split range ? where it is used ? in which control loop it is used ?

0 Answers  

---