why is an oxygen sensor used in a boiler stack

Question Posted / rachid

2 Answers
7429 Views
HCL, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why is an oxygen sensor used in a boiler stack..

Answer / mithilesh kumar

Oxygen sensor is a vital role in boiler.we maintaim
3-5%.
In atmoshphere 21% oxygen.
So if we are feeding coal in boiler at running plant,
or hot lightup or coldlightup that time it's role is very
important.ie it's shows coal burning or not.

Is This Answer Correct ?

5 Yes

1 No

why is an oxygen sensor used in a boiler stack..

Answer / ravi kumar

since oxygen is necessary to create firing in furnace,the oxygen sensor is placed so to matain the combustion control for the fuel used

Is This Answer Correct ?

2 Yes

2 No

Post New Answer

More Instrumentation Interview Questions

what are level of automation & how these are distinguished ?

3 Answers

difference between vaccum and draft

0 Answers

How will you calibrate an Absolute Pr.Transmitter of range 400mmHg absolute ?

0 Answers CCIE,

in instrumentation why we are using 4-20mA , why not voltage ? if somebody design a instrument which works on voltage then can we use that instrument?

6 Answers

Level in tank under vacuum (Ex: Condensate Tank of Power Plant)is measured using D. P. type level transmitter. Tank is subjected to vacuum of 755mmHg. Is it possible to fill wet leg ( i.e. leg connected to top of vessel with low point of D. P. xmtr) with water?. Are there chances of water getting sucked under vacuum? if yes, what is the solution?

3 Answers

How I identify to solonied coil which is 24v or 230v In our lab.because there is no tag.

1 Answers MRPL Mangalore Refinery and Petrochemicals Limited,

How to gennerate earth leakage monitoring alarm for solenoid valves in control system?

2 Answers

How do you troubleshoot accelerometers used in Vibration monitoring/tripping

1 Answers Air Liquide,

what is three element loop

7 Answers

If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?

0 Answers

i hav applied for the post of engg. in iocl so please require the past test papers fro instrumentation engg please please help me and send me the papers or tell me the pattern and type of ques asked in examination......

0 Answers

what is the diffrence between LCN and UCN

2 Answers

For more Instrumentation Interview Questions Click Here