Answer / sushil jambhulkar

3 ELEMENT IN LEVEL CONTROL ARE
1)FEED WATER FLOW(INCOMING)
2)STEAM FLOW(OUTGOING)
3)LEVEL
A)FEED WATER FLOW SIGNAL IS A COMPENSATING VALUE OF ITS
TEMP & PRESSURE
B)STEAM WATER FLOW SIGNAL IS CONPENSATING VALUE OF ITS TEMP
& PRESSURE.
C)LEVEL SIGNAL IS AVG VALUE OF ALL LT INSTALLED ON DRUM

SIGNAL A,B & C INPUT TO FLOW CONTROLLER FOR DRUM.

What happen if I install my pressure transmitter below the elevation of pipe in natural gas service?

0 Answers  

---

How to gennerate earth leakage monitoring alarm for solenoid valves in control system?

2 Answers  

---

1 > HOW TO MEASURE INTERFACE LEVEL 2 > DIFFERENCE BETWEEN RADAR & ULTRASONIC LEVEL TRANSMITTER

3 Answers   Atul Auto,

---

If the vibration probe near to the shaft,then output voltage will be decreased r increased?How?

1 Answers   Amtek, Hamsco, IJT,

---

can install leveltrol in steam drum for measurment the level of steam drum? if not then why?

1 Answers  

---

What are difference between automatic and manual control system?

5 Answers  

---

why using negative supply for bentley nevada vibration system ?

0 Answers  

---

Please explain the difference between instrument range and calibration range in terms of pressure transmitter? line design pressure: 93 bar operating pressure : 82 bar press Transmitter Range? calibration range ?

3 Answers   L&T,

---

how we will install a positioner ?

2 Answers   Descon,

---

Sir i am studying M.sc,(Tech.)Electronics and Instrumentation in Andhra university.What is the offers for me?

4 Answers  

---

what is a half wave, full wave, and bridge rectifer.

0 Answers   Takreer,

---

Explain the mechanism behind the turbine meter.

0 Answers  

---