Answer / chirag nihalani

if u do the adjustment in the string at the actuator, or 
compress the spring, u will get the opposing force to move the 
stem in the control valve that is called bech set .it depents 
on the control valve. mostly foe small valve we use 3-15 psi 
and for medium we use 6-30 psi .thanks

diff between dead wt calibrator n pressue comparator?

4 Answers   Invensys,

---

testing of thermo-couple?

3 Answers  

---

What is fault tolerent system

2 Answers   GNFC,

---

how to wire from pressure transmitter to marshalling panel and panel to controller and controller to dcs plz give the answer with example .

2 Answers  

---

If I want to buy a pressure switch & 3-way valve for hot water application then witch parameter I should consider.

1 Answers  

---

what is zero and span ?

0 Answers  

---

We have ZR22G-100-S-A-E-T-T--E-A/CV/F1 Model Zirconia Oxygen analyser which is Yokogawa make. I kept the analyser in Flue gas path at Air pre heater area. My plant is 7.5MW Biomass power plant. For a particular fuel, Coconut Husk which contains Sodium and Potassium chlorides iam not getting proper reading, Analyser output always Zero. I calibrated the analyser and it is OK. For Other fuels like Wood chips, Cholam waste, DOB, Groundnutshells, Ply wood waste and all iam getting actual percentage of Oxygen. What is the main reason behind this draw back?

2 Answers  

---

How a pH sensor & analyzer work at waste water treatment plant, whats the principle & science is beyond this,How pH sensor sence & convert signal & move toward analyzer & analyzer show reading in percent? also what is temperature compensate option in analyzer

1 Answers  

---

what is the main supply source for pressure transmitter?

1 Answers  

---

WHAT IS DIFFERANCE BETWEEN INSTRUMENT AND EQUIPMENT

1 Answers   Lupin,

---

What is the basic difference between Modbus and CAN Open Protocols

0 Answers  

---

What is negative range in transmeter?

1 Answers   TCL,

---