Answer / jaffer

differential pressure transmitters:

1.both side applied a pneumatic pressure in the h.p&l.p side
check the response on the dp cell.
2.equal pressure on the both side and then transmitters shown
a zero value.
3.upper range value(URL)on the h.p side 10,000mmwc or 1kg/cm2. this value depend on process reqirement.
4.lower range value(LRL)on the l.p side 0 mmwc or 0 kg/cm2.
5.And then change value&change the tag no.
6.check the states of the transmitter. by the help of field calibration devices.

pressure transmitters:
1.the pressure transmitter is only one physical quantity sensing input&applied a input and then same 2,3,4,5,6steps.

Can combine control system for Emergency control system (ESD)and Fire & Gas System ( F & G) is possble to built and offer to client? Can such system is as per Norms in India?

0 Answers  

---

The document / drawing that is primarily used in depicting the “Bill of Materials (BOM)” of piping system is the

2 Answers  

---

hi my name is rakesh patel i just complited my be in instrumentation & control now i am going to working as a validation engineer in a poject department so what is a scope in a future as a validation engginer ? what line is good for me can any bady give me complete solution please? your regard rakesh patel

0 Answers  

---

WHY TEMPERATURE TRANSMITTER USED AS WE CAN CONTROL THROUGH THERMOCOUPLE/RTD

5 Answers   Samsung, Thermax,

---

i install a DP transmitter of Faugi on drum level of boiler but i face a problem in it when i engergize the transmitter the meter shows 0 or 100% no variation in it.the distance of two points is 19.5 inches, i am in trouble please suggest me what can i do it's very urgent Please reply me as soon as possible Best regards ikraam haider

5 Answers  

---

What is Fieldbus?

3 Answers   NSL,

---

how can i check vortex shedder bar it is ok? if there is ohms condition are shown correct?

0 Answers   Chevron Phillips,

---

I have a Control VAlve having size of 2 ".Only the known parameter is Pressure drop . Its 2 Kg. Then How to calculate control valve sizing means Cv.

0 Answers   JSW,

---

How to calibrate DP tramitter in flow measurement application? consider my range of flow is 0 to 2000 kg/hr ? please give calculation of , How much pressure applied on low pressure side and high pressure side please give detail of calculation .... It so important for me please reply as soon as possible

1 Answers  

---

what is the formulae to find the thermocouple output to temperature

5 Answers  

---

hello friends, can you please send me the model paper or question paper to be prepared for hpcl examinations????????? You can mail me at rahim_here@yahoo.com waiting for your reply........... help me .. plz.....

0 Answers  

---

An electronic p controller has an input range of 1-5v, and output range of 4-20mA, while testing a step change of 0.4 was applied at the input , the PB setting was 50% ,what should be the change in the output ?

1 Answers   Reliance,

---