Answer / sagar tiwari

formula for lap length
dx50=mm for m20 grade

for example-12x50=600mm

where d is the diameter of bar.

Answer / sankardas banerjee

40 TIMES OF THE DIA OF REINFORCEMENT IS THUMB RULL.

Answer / chinnasamy.g

compersive member=45d
tensile member=50d
d=dia of bars

Answer / ankur shrivastav

According to IRC 21:2000, clause 304.6.2----

Development/Lap Length is depends upon various factor--
like-
1. Grade of Concrete
2. Grade of Steel
3. Bonding Zone

Lap Length will be- nx Dia
Value of n is as below-

M20 M25 M30 M35 M40 and above
Fe500 66 56 48 42 42

Fe415 55 46 40 35 35

Fe 240 65 60 55 50 50

These values belongs only for bonding zone-1*.

For Bonding zone 2- n=1.4 x value of "n" in bonding zone 1

* Bonding Zone 2- Bonding Zone 2 is a zone where bar has been bent less than 45 degree angle and more than 300 mm fresh concrete is casted below the bars.

All other locations are bonding zone 1

Answer / m. vijayshankar

In between 40 times to 50 times according to the structural
consultant advise.

Answer / dronachari

50d, compressive zone 24d,Tensile zone 40d

What is the difference between Design and nominal mix?

2 Answers   HHH,

In the present situation of ban on mining sand from rivers,can we go for formation of earth dam filters viz;Horizantal sand blanket,inclined chimney and filters under rivetment with crushed rock sand of 6mm down size.If so what are the specifications and is there any codal provision for its authentication?

0 Answers  

what is advantage of vdf flooring ?

2 Answers   FH, NSL,

what is mant by point of conter of fracher(p.c.f)

6 Answers   TCS,

Before casting a basement roof slab which is connected with retaining wall surcharge load (i.e. sand or earth filling) outside the retaining wall is prohibited because of––

0 Answers  

how can calculate qty of steel required for one or two ways slabs..

1 Answers   Proscape LLC,

How is make concrete cube?

0 Answers  

how to calculate cement mortor for wet and dry mix for different ratios

1 Answers  

How you can turn off the display for dimension in CAD?

0 Answers  

Why we used ther red bricks for construction..

1 Answers   Lodha,

brick work with 1:6 cement mortar how many bricks and cement and sand require for 1cum

3 Answers   Arma Group,

i know that, the for calculating material required for concrete volume of concrete is taken 50-54 % more for wet volume. i have querry is that cement and sand volume taken more for making wet volume but in the case of aggregate why it is taken more there is no change in aggregate whether it is dry or wet.???? can you give me answer for this???

0 Answers   QRI,