ABB DCS (AC 800 M)redundency take howmany milliseconds to switch from master c

ABB DCS (AC 800 M)redundency take howmany milliseconds to switch
from master controller to slave?should be less than DCS scanning time?

Question Posted / narasi23

2 Answers
6382 Views
SCS, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

ABB DCS (AC 800 M)redundency take howmany milliseconds to switch from master controller to slave?s..

Answer / muthu

taken over in less than 5ms

Is This Answer Correct ?

7 Yes

1 No

ABB DCS (AC 800 M)redundency take howmany milliseconds to switch from master controller to slave?s..

Answer / anand.r biocon limited

less than 10 ms

Is This Answer Correct ?

0 Yes

1 No

Post New Answer

More Instrumentation Interview Questions

What is zone,loop/fire alarm system?

0 Answers Emco,

What is PID tunning

2 Answers EID Parry, MFL,

It is desired to reduce effect of 50Hz pick up in a thermocouple measurement. If a third order LP filter is used for this, what should be its cut off frequency, if gain should be 0.001 at 50Hz.

1 Answers Honeywell,

what is thermocouple output

7 Answers IPCL,

which type signal come control valve

6 Answers

what are the basic instructions used in simatic s7-300 plc?

5 Answers Dr Reddys, HZL, Siemens,

Can we use twisted pair cable instead of ethernet for communication?

1 Answers Yokogawa,

whats the problem will arrise if we rotate the hosing screw of the differential pressure transmitter?

1 Answers

What is instrumentation control?

0 Answers

in sulfur process what is material of impulse line we use to connect with transmitter ? and does teflon affected by sulfur?

0 Answers

䑰ҕ䔈ҕ䖠ҕ䘰ҕ䛀ҕ䝐ҕ䟐ҕ䢐ҕ䥐ҕŹ

0 Answers

What are advantages and disadvantage of the ac supply load cell?

0 Answers

For more Instrumentation Interview Questions Click Here