if tx. dp increase or decrese what happend in the reading

1 Answers   BSP,

---

what is function test.

1 Answers   Takreer,

---

what is the protection system in solar turbine compressor

0 Answers  

---

why is an oxygen sensor used in a boiler stack

2 Answers   HCL,

---

i want know about capillary type LT transmitter installation. we can install any location in between to HP and LP leg?

2 Answers  

---

---

I have transmitter of range -20 to -5 kpa.if it is possible to zero trim with atmospheric pressure,means HP and lp having no pressure...what will get after zero trim and it is the right way.....plz give me reply ....

3 Answers   KOC,

---

What are primary elements of measuring pressure?

0 Answers  

---

While preparing the graphic diagrams trend display, 3 types of trends are prepared by Yokogawa system vender. These are for process variable, manipulated variable & set point variable. Why these 3 trends are required? Explain the purpose of these 3 trends.

1 Answers  

---

What is rtd output signal

4 Answers   Nestle,

---

Why thermo wells are used?

1 Answers  

---

During valve sizing from all calculation you got flow coefficient CV 12,than what it means? like for selecting pressure transmitter if your MAWP is 12 bar than you select a capsule of max. 20 bar which cover your mawp 12 in same way for selecting control valve If CV is 12 than how we use it in selecting valve??????

1 Answers  

---

pressure switch range 0 to 2bar.i have to install from ground level to 5 meters height.what is the formula the to increse the range ? and every 1 meter how much pressure should be add ?

3 Answers  

---