Answer / bhargav purohit

I think this question is to make you confuse. Because cables
using in ethernet are twisted pair (UTP- unshielded twisted
pair)

Regards,
Bhargav Purohit

I want to install analog type, flange mounted gas flow meter (line size - 2"), for CNG flow measurement.Kindly give some details of flowmeter or suppler name, available in India.

1 Answers  

---

what are the basic instructions used in simatic s7-300 plc?

5 Answers   Dr Reddys, HZL, Siemens,

---

principle of automatic votage regulator

0 Answers   Bhel,

---

what is weighfeeder

2 Answers  

---

How Many Slave Can be used in one slave ?

2 Answers  

---

Which type of pressure can be measured by these elements?

0 Answers  

---

A pressure differential gauge type of instrument has a manifold with 2 isolation valves (hp and lp),2 vents(1 each for hp and lp) and 1 equalizing valve. Determine the position of each valve(either fully closed or fully open) when troboulshooting to: 1. zero the transmitter. 2. determine if there is a block in the impulse line. 3. determine if the gauge is functioning properly. The process fluid is water.

1 Answers  

---

modbus and profibus communication difference?

1 Answers  

---

what is the well head protection system?

1 Answers  

---

What is the meaning of the term "g force"?

3 Answers   Reliance, Saint Gobain, Thermax,

---

1. what is 3 point calibration & 5 point calibration? 2. If we use hart communicator to set the LRV & URV of a smart transmitter, did we calibrate the transmitter? why? 3. Make a complet list if meterials needed to properly connect a pressure gauge to a steam pipe using 1/2 inch stainless steel tubing. The gauge connections is 1/2 inch NPT-M and the steam pipe tap has a 1/2 inch female coupling, compression fittings are use. 4. What are the tools in loop checking? 5. What would the ISA symbol of a square root extractor look like? 6. What would you do to completely prepare for the configuration? 7. What safety measures must you undertake when doing configuration? 8. what are the two most commonly use programming languages used when we configure a PLC? 9. What would you do if you accidentally skipped a step in the configuration procedure? 10. How would you know if the configuration were sucessful? 11. Name at least 3 selections available when we configure the burnout protection of a controller?

3 Answers   EI Electrotechnical Institute,

---

For a diafhram 1.5 d =kn(p-p0) D4 Where d in deflection in inch k=constant n=no of capdule (P-P0)=Applied pressure in psi D In active dia at capsule. -1.5 d=k to p d being constant -1.5

0 Answers   L&T, Shiv Tech Marine Control,

---