Answer / aftab ahmed mazari

1. Monitor's 3 wires should be connected to Proximitor.
2. Monitor's 3 wire means (a). Power supply for Proximitor wire (b). Common wire (c). Input wire to Monitor.
Now I am connecting from probe (sensor) end.
3. Install probe at fixture.
4. Connect probe connector to extension cable connector
5. Connect Extension cable other end to Proximitor.
Let I explain another way: Probe -> Extension Cable -> Proximitor -> Monitor
aftabmazari@yahoo.com

what is load line in control valve?

3 Answers   Boral, Qatar Petroleums,

---

how many parts of valve positioner?

1 Answers   Kentz,

---

what is interface level and how it is calibrate?

0 Answers  

---

How to Calibrate Level Switch in field

0 Answers  

---

How an rtd work, and what volts/current goes to a rtd to measure the resistance?

0 Answers  

---

How to convert mmWc(mili meter water colam) to tph(ton per hour)?

0 Answers  

---

why 1 to 5 vdc is used for output measurment

4 Answers  

---

If the on Of the DO module is off in the System cabinet, then what is the Procedure to check weather the Module is working or not.

2 Answers   Honeywell,

---

list of flame proof certification ?

1 Answers   TATA,

---

A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?

0 Answers  

---

send me last 5 years questions asked in rrb chennai, for section engineer

0 Answers   RRB,

---

The process variables that need to monitored and controlled are ________, ________, _________ and

1 Answers  

---