why is honed type flow orifice plate? what purpose it used? how to select this?

why is honed type flow orifice plate? what purpose it used?
how to select this?

Question Posted / rajesh.m.kon

4 Answers
17931 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

why is honed type flow orifice plate? what purpose it used? how to select this?..

Answer / sabry

Actually It's called "Honed meter run".

It's a 1 piece manufacturer piping assembly, used to hold the orifice.

It's called "Honed" as the piping internal surface is honed/machined to be glass smooth surface.

This assembly is very expensive & it's used in custody transfer applications.

REFERNCE"Lessons In Industrial Instrumentation"/Page:584,585.

Good Luck

Ahmed Sabry
I&C Senior Engineer
Cell:+2 (0122) 1367310

Is This Answer Correct ?

7 Yes

1 No

why is honed type flow orifice plate? what purpose it used? how to select this?..

Answer / inst & control eng

Honed flow sections are orifice runs made in sizes of 0.5"
to 1.5". These devices are used for low flows of gas,
liquids and steam services with a higher tolerance than
standard sized orifice flow measurement of pipe line size
more than 2".

Is This Answer Correct ?

2 Yes

0 No

why is honed type flow orifice plate? what purpose it used? how to select this?..

Answer / murali

to create the differential pressure from that you cam
derive the flow of media

Is This Answer Correct ?

0 Yes

4 No

why is honed type flow orifice plate? what purpose it used? how to select this?..

Answer / rathna

Horn type orifice mean, it is FLOW NOZZLE

Is This Answer Correct ?

1 Yes

6 No

Post New Answer

More Instrumentation Interview Questions

what is the PID controller?

1 Answers

what is the calibration procedure for transweigh make weigh feeder?

0 Answers Anjani Cements,

why we are maintain the gap voltage in vibration probe when installing time can explain me?

1 Answers CIL,

Where we cant instal mass flow meter.

1 Answers

why we are using negative range like -750 to 0 mmwc in closed tank?and what is the reason can you explain clear?

2 Answers Aarvi Encon,

Wht is Dry Leg Calibration and Wet Leg Calibration?

2 Answers

Could you explain to me the enraf (servo gauge) mechanism. How it works ? and how it is working on archimedes theory while it's not immersed into the surface? and how can we calibrate it ? Thanx

1 Answers

how do calibrate the valves.. with clear manual

0 Answers Essar,

SIR MAY I KNOW IF RADAR TYPE LEVEL TRANSMITTER SHOWING IN THE FIELD 0 % LEVEL AND IN DCS SHOWING 100% THEN WHAT IS THE CAUSE I CLEAN THE CHAMBER & TAKEN ONLINE BUT ONLY ONCE ITS BECOME ZERO IN DCS BUT AGAIN 100% SHOWING IN DCS,THEN I REMOVE THE POWER SUPLLY AND CONNECT IT AGAIN .IS IT OK BUT STILL IN THE DCS ITS 100% AND ON THE DISPLAY ITS INITILAZIATION PLEASE HELP ME READRING THIS?

4 Answers

why is an oxygen sensor used in a boiler stack

2 Answers HCL,

Why we using 250ohm resistance during lab calibration and why not using in field in one plz define deeply???

1 Answers Cisco,

testing of thermo-couple?

3 Answers

For more Instrumentation Interview Questions Click Here