What is safety barrier and how it is work

Answers were Sorted based on User's Feedback



What is safety barrier and how it is work..

Answer / vikash shukla

safety barriers are device which are used to lower the electrical energy when transmitting signal from hazardous area so that combustion and other accidents can be avoided.

Is This Answer Correct ?    6 Yes 4 No

What is safety barrier and how it is work..

Answer / raja2016

safety barriers simply neglecting the spike voltages from the field that affecting the electronic I/O cards in the PLC system by fuse blow down in it
.

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More Instrumentation Interview Questions

Why we use 250 ohm resistor in series with HART protocol communication?

13 Answers   Chemtrols, Instec, Sabic,


Why MUX JB's are using only Temperature Element in Fundation field bus?

0 Answers   Reliance Industries,


What is the use of temprature compensation?

0 Answers  


How can we test a bently nevda 3500/42M accelerometer monitor card by simulating it with test equipment?. what king od of signal (milli volts or volts or or resistance ) we should feed in the terminals of the card?

0 Answers  


what do u mean by 2/3 soleniod valves?

8 Answers   Nile Sugar,






what happen if i install my pressure transmitter below the elevation of pipe in natural gas service. Also support your answer

3 Answers   C2C,


how to rectify the poor signal strength in utrasonic digtial flow meter ,model:ge digital xce868i

0 Answers   KNPC,


In VVVF DRIVES VOLTAGE IS ALSO VARY WITH THE FREQUENCY. HOW? WHAT IS THE DIRECT FORMULA RELATING THESE TWO.

0 Answers   India Cements,


Can any one send me IOCL instrumentation question papers.. i dont know the pattern of the questions and what to prepare can any one help me on this .. my email id is anwarnishil@gmail.com

0 Answers  


Name four general (not technical) criteria that would you consider important, when deciding upon a particular control valve?

1 Answers  


Are Coils of Electromagnetic flowmeter in direct contact with fluid material

4 Answers   TATA,


Instrumentation engineer please reply me,I am electrical engineer ,what is the future in instrumentation dept {presently working (P&ID) Design} for me,whether good future for me as instrumentation department.what side can i get job in future

3 Answers  


Categories
  • Civil Engineering Interview Questions Civil Engineering (5085)
  • Mechanical Engineering Interview Questions Mechanical Engineering (4451)
  • Electrical Engineering Interview Questions Electrical Engineering (16632)
  • Electronics Communications Interview Questions Electronics Communications (3918)
  • Chemical Engineering Interview Questions Chemical Engineering (1095)
  • Aeronautical Engineering Interview Questions Aeronautical Engineering (239)
  • Bio Engineering Interview Questions Bio Engineering (96)
  • Metallurgy Interview Questions Metallurgy (361)
  • Industrial Engineering Interview Questions Industrial Engineering (259)
  • Instrumentation Interview Questions Instrumentation (3014)
  • Automobile Engineering Interview Questions Automobile Engineering (332)
  • Mechatronics Engineering Interview Questions Mechatronics Engineering (97)
  • Marine Engineering Interview Questions Marine Engineering (124)
  • Power Plant Engineering Interview Questions Power Plant Engineering (172)
  • Textile Engineering Interview Questions Textile Engineering (575)
  • Production Engineering Interview Questions Production Engineering (25)
  • Satellite Systems Engineering Interview Questions Satellite Systems Engineering (106)
  • Engineering AllOther Interview Questions Engineering AllOther (1379)