Answer Posted / aftab ahmed mazari
1. Monitor's 3 wires should be connected to Proximitor.
2. Monitor's 3 wire means (a). Power supply for Proximitor wire (b). Common wire (c). Input wire to Monitor.
Now I am connecting from probe (sensor) end.
3. Install probe at fixture.
4. Connect probe connector to extension cable connector
5. Connect Extension cable other end to Proximitor.
Let I explain another way: Probe -> Extension Cable -> Proximitor -> Monitor
aftabmazari@yahoo.com
Is This Answer Correct ? | 3 Yes | 0 No |
Post New Answer View All Answers
Can I route 110 VDC and 24 VDC in a same Duct for our Interposing relay cabinet? IF yes or NO Please provide me IEEE Std. for the same. Please i required it on Urgent basis, i need to design IRP Cabinets and we have MCC 110VDC and Our Coil side is 24VDC, Please help as soon as possible.
anybody having Qatar Petroleum questions for instrument Technician offshore ....please send me
What is the use of gauge?
Draw a complete P&ID of a flow suction tank indicating all control & protection equipment. Indicate all its inlets and outlets. Explain the controls for this system
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
Describe the typical instrumentation used in monitoring the performance of a shell and tube heat exchanger.
How to calibrate the flow transmitter
you must show the examples application and give at least 4 types of transducer/sensors that can minimize the failure during the manufacturing of the resistors.
How to Calibrate Flow Switch in field
Explain the mechanism behind the turbine meter.
I want to buy a seal kit of a pneumatic power cylinder.But I don't know it's specification.So please help me to know its specification.
sir, give me placement papers and interview quistion of birla group company of copper.
What is 3 selection available when configure the burnout protection for controller
In Safe Guarding test what means by "Failed to Danger" ?
What are different types of valves?