Answer / sreedhar

First Measure The Height Of The Drum From HP To LP. For Example If It Is 500 mm. Then The LRV is -500 mmh20. URV Is 0 mmh20. Because It Is Steam It Will Condensate So We Have To Use Wet Leg. If There Is No Level In Drum, We Will Fill The LP Impulse Line With Water So 500 mm pressure Will Act In LP Side So It Shows 0% Level. When The Level Starts To Raise In The Drum The HP Pressure Will Increase And It Will Show The Corresponding Level.

Somebody ask me how many size of control valve what is mean of control valve size?

2 Answers  

---

how to use K thermocouple instead E- type without compesation cable

1 Answers  

---

In your own words, would you expect an ultrasonic level device to work better in a pressure vessel with a high pressure or a strong vacuum, and why?

1 Answers  

---

a pressure transmitter with a range of 0 to 2500kpag has a specified accuracy of 0.5 % of span.It is to be calibrated using a comparison gauge to have an accuracy of 0.1% of span.The comparison gauge has a range of 0 to 3000kpag What is the accuracy ratio? is this ratio acceptable?

2 Answers  

---

How to connect another 24 volt dc power supply in circuit when previous power supply has become weak.what is the connection?

2 Answers   Bhole Baba Dairy Industries,

---

ORP sensor working principle?

0 Answers   Tata Steel Limited,

---

difference between span and range

3 Answers   IOCL,

---

How to derive IO Count (AI, AO, DI and DO ) from a Field instrument (FI) Bill of Quantities (BOQ) given by client.

1 Answers  

---

why does a transmitter o/o signal starts from 3-15psi or 4- 20mA?

11 Answers  

---

hw to calibration a control valve?

3 Answers  

---

In bimetallic temp. Gauges why does metal strip bend? Why do we use low expansion factor metal and high expansion factor metal in bimetaliv strip?

1 Answers   Process Control Technologies,

---

Difference HAZOP and HIRA

1 Answers  

---