Answer Posted / sreedhar

First Measure The Height Of The Drum From HP To LP. For Example If It Is 500 mm. Then The LRV is -500 mmh20. URV Is 0 mmh20. Because It Is Steam It Will Condensate So We Have To Use Wet Leg. If There Is No Level In Drum, We Will Fill The LP Impulse Line With Water So 500 mm pressure Will Act In LP Side So It Shows 0% Level. When The Level Starts To Raise In The Drum The HP Pressure Will Increase And It Will Show The Corresponding Level.

What is the use of GMV in turbine?

4509

---

what is the calibration procedure for transweigh make weigh feeder?

4066

---

ORP sensor working principle?

2065

---

Can u tell me the principle of the tc,rtd,level switch,pressure switch ,transmitter(pr flow level temp.),vibration...plz

2097

---

What is the use of control cable?

1205

---

sir ,iam in dem urgent need of HPCL Paper of Instrumentation Branch plz send me at your earliest convenience at ujjwal_sharma1983@yahoo.com

2561

---

1.what is controller proportional gain 2.what is the controller intergral action time. 3.A proportional plus derivative controller that has a proportional band of 20% and a derivative action time of 0.1 minutes. Construct the shape of the output waveform for the triangular input if the input rises and falls at the rate of 4 units per minute.

2735

---

principle of dead weight tester ?

2128

---

what is the vital subject for scoring bhel exam&what is the question pattern

2472

---

How oil line flow measured?eplain about instruments used and working principle?

2100

---

if my flow is 20000 m3/h than which range of DPT i have to use????

1874

---

What are primary elements of measuring pressure?

1358

---

Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?

1941

---

how can leve transmetter calibate in feild .and also put cv and flow plz .....

2292

---

how to calibrate Necleuonic level transmitter.?

2154

---