In your own words, would you expect an ultrasonic level device to work better

In your own words, would you expect an ultrasonic level
device to work better in a pressure vessel with a high
pressure or a strong vacuum, and why?

Question Posted / kamal

1 Answers
5214 Views
I also Faced
E-Mail Answers

In your own words, would you expect an ultrasonic level device to work better in a pressure vessel..

Answer / pavan wagh

At high pressure in pressurized vessel ultrasonic signal gets suppressed substantially ,same is the case with strong vacuum where medium (air) of signal transfer is absent.
In both cases DP transmitter is the best choice for good accuracy. For level measurement with DP transmitter density compensation is essential,as liquid (water) density changes at high pressure and high temperature.

Is This Answer Correct ?

2 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

What is BMS (Building Managment System)& is AHU / HVAC are in BMS.

12 Answers Alghanim,

In RS 500 SLC 5/03 input change one module card to another card, plz. give steps clearly.

0 Answers BHL,

What is the formula to know the error of weighfeeder after having drop test.

3 Answers

if the neutral and ground of ups voltege are connected together in the source itslef then why the voltege b/w neutral and ground comes positive in some other destination inspite of having earth pit. how can we mimmise this?

1 Answers

why 4-20 mA signal is preferred over a 0-10V signal

17 Answers Sofcon,

I want measure the volumetric flow of gas in waste heat recovery Boiler?Tell me how and which type of instruments required. Plz mail me:naba02222@gmail.com Sam please post the answer .

0 Answers

hydrogen purity meter calibrating and commissioning procedure can be explained?

1 Answers

For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?

0 Answers

A DP Endress and Hauser flow transmitter is always tripping pump at low flow. set point is 74 cubic meter/hr. Thorough impulse line flushing and zero calibration has been done, yet problem persists. What do you think is the problem and how do you rectify this fault?

5 Answers

what is protonics how it is differ from electronics

1 Answers

What is difference between ESD and PLC please Explain me clearly.

0 Answers

I am applied 100 % pressure on to the air to open control valve,but the valve is not fully closed..and 10-15% is open the valve. how to calibrate the control valve?

3 Answers OPaL,

For more Instrumentation Interview Questions Click Here