Answer / sarath kum

12 psi will be the out put

WHAT IS DIFFERANCE BETWEEN INSTRUMENT AND EQUIPMENT

1 Answers   Lupin,

---

I want to use 1/2 inch SS316 tube in my high pressure & temperature (64 kg/cm2 & 500 deg C)after condensate pot in pressure tranmistter. 1) Is it possible to use 1/2" ss316 tube in high pressure and temperature line. Tube manufacturer is local vendor. 2)On sarting the plant, We need to do system fluse that time condesate is not in the condesate pot so steam is directly contact with the tube. We have no exact calculation to know our tube is ok or nor at this time. pleae,reply.

1 Answers  

---

1.In which princeple DP transmeter works? 2.Why UPS system is use for DCS? 3.How drum lvel controller works? 4.What is the difference between glob valve and gate valve? 5.How axial shift probe work & in which princeple it works?

1 Answers   Luberef, Qatar Gas, Reliance,

---

Yokogawa mass flow meter shows negative reading...what r the main causes for this problem?...

3 Answers   IOCL,

---

When a timer is placed in RS Logix 5000 with preset value less than its scan time it is malfunctioning. i.e., if the preset is set to 30ms still the timer TT bit is counting till 150ms(its scan time). Any solution for the problem?

2 Answers   Balco,

---

How to carry out hot loop checking of closed loop pf temperature control valve & temperature transmitter?

2 Answers  

---

What are the processes Variables?

4 Answers  

---

kindly tell where orifice,nozzle,air foil,ventury used in flow measurement?

1 Answers  

---

i have a dp tx range is 5000mmwc. in which calibration i use in a open tank.1.5*3.5*2.5 mtr.for level msmnt. what is the calculation.

2 Answers   Bajaj Hindusthan,

---

which processor is used in dcs.

0 Answers   ABB, Wave Distillery,

---

What is difference between loop and zone ?

5 Answers   Adgas, Bilt,

---

what is the use of impulse line in AFBC boiler , WHY WE CONNECT IMPULSE LINE TO TRANSMITTER , DRFT GAUGE ETC ????????

6 Answers   Jindal, Reliance,

---