If range of 3-15 psi, a multiplying relay with a 1:2 ratio
would give what output pressure for 6 psi input?
- 1 Answers
- 3553 Views
- I also Faced
- E-Mail Answers
Answer Posted / sarath kum
12 psi will be the out put
| Is This Answer Correct ? | 4 Yes | 0 No |
Post New Answer View All Answers
How it the difference between force balance system and dispalacement balance system?
How to calibrate Magnetic flow Transmitter in Field
A DP transmitter is used to measure the level of an open tank. The drain line of the tank is connected to a control valve, and is configured as, if the level of the tank is 90% the valve should get open 10%. And if the tank level is 10%, the valve should get open 90%. Draw wiring diagram and explain how to configure DP transmitter and control valve using HART communicator. If the span error at output is 1%, what will be the %opening of the control valve at 60% level of the tank?
Operational amplifiers
what is IEC code in cables & how to selecting cables?
In Safe Guarding test what means by "Failed to Danger" ?
what is diffrance between FF & SMART, explain with difination
If a warning lamp will operate with the ground circuit is bypassed with a jumper wire to ground, what should you check?
describe flow nozzel principle?
how 3 out of 2 Logic/interlocks works? give brief explanation with help of diagram.
Specify eight technical requirements that you would consider important, when deciding upon a particular control valve?
How does your previous experience relate to the job you are applying for ?
Drum level tx with GP4 with zero elevation:7300mmh20 on HP and 8050mmh2o on LP as range but on commissioning the tx readiing is max,Why this reading?
Hi i am aneesh, done btech in applied electronics & instrumentatiin. And then i took mba in finance & marketing.After that i got placement in finance co and worked there for 3.5 yrs.Now i wanted to come back to engineering job.But without engg experience, i may not able to find an opening.i have done a course related to flow meters and ite calibrations. Kindly suggest where should i try to get a job?
the output of the common trasmitter protocol in qatar gas are the following
