when an eddy current probe is installed inside of a turbine or compressor in ca

when an eddy current probe is installed inside of a turbine
or compressor in case of probe problem same as:crash of head
of probe,changing the scale factor because of low measuring
gap(physical gap is ok(example=1.14mm)but voltage is
reduced(example=-6 volts),is any way to check the probe,when
the ohm of probe is ok.thank you,(Karim Tavakoli)

Question Posted / karim tavakoli

1 Answers
2846 Views
I also Faced
E-Mail Answers

when an eddy current probe is installed inside of a turbine or compressor in case of probe problem ..

Answer / kumar

proximity probe tip is wound on coil if any damage in tip won't get reading. proximity probe installed in -6v gap voltage didn't get proper microns because that time magnetic flux line is not created fully so we installed probe in -10v this time probe 200 microns/mills or 100 microns/mills we get exact variation in probe

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

Which type of pressure can be measured by these elements?

0 Answers

what is RPI and NUT in controlnet networx. what happen if we are increase the NUT of controlnet networx?

1 Answers Schneider,

our kks tagging is crossing more than 12 character please suggest how to take tags in the DCS

0 Answers

Why we use 4 to 20 mA, (This is International Standard) instaed of this can we use 4-16, or 4-24 or 3- 15 or any other range

13 Answers ONGC,

What is hp & mp seperator .& what is its working principle ?

0 Answers

In case of Transmitter's(e.g.Ultrasonic Flow meter ) we have an normal practise of selction of upstream and downstream distance such as (20D and 5D ).can anyone please let me know whow to calculate "D" ?? i guess it refers to pipe thickness is t right ?

2 Answers

What is the absolute temperature

2 Answers

what is span value and zero ? and how set ?

0 Answers

Positioner usage.

0 Answers CCIE,

A pressure differential gauge type of instrument has a manifold with 2 isolation valves (hp and lp),2 vents(1 each for hp and lp) and 1 equalizing valve. Determine the position of each valve(either fully closed or fully open) when troboulshooting to: 1. zero the transmitter. 2. determine if there is a block in the impulse line. 3. determine if the gauge is functioning properly. The process fluid is water.

1 Answers

what is mean of 3 by 2 automation ?

5 Answers

What is the detail function of I/O card in DCS ? Why we dont use the I/O directly with controller?

3 Answers Kekran Mekran, TCE,

For more Instrumentation Interview Questions Click Here