Answer / janab

mV is the approximate voltage which is considerd for
voltage drop calculation

Answer / apoorva

mV is mili volt n used for the measurement of voltage and mA mili ampere which is used for current..

square root calculation for dp flow transmitter? give me a explanation with example

3 Answers  

---

Can we use thermocouple in generator of power station replace RTD(pt 100)? if we don't have any place for use RTD.

2 Answers  

---

when the instrument tapping on pipe line is located below and transmitter is located above the tapping point for liquid service transmitter, what should we do, is there any additional drain valve is required??

2 Answers  

---

what is meant by orderm of a system. will the stability of a system increases by incresing order of a system

1 Answers  

---

why is an oxygen sensor used in a boiler stack

2 Answers   HCL,

---

WHEN DO WE GO FOR FMCW TYPE RADAR & PW TYPE RADAR ?

1 Answers  

---

what is the differnce between PLC & DCS

7 Answers   TVS,

---

Pls.could any one Clarify the following with an example. 1.At What condition Close on Rise and Close on Fall Pressure Switch contacts are used. 2.If Pressure is abnormal as per set pressure,if connecting Terminal of pressure switch breaks,how the voltage extends to Relay base. 3.Are these contacts come under fail safe philasaphy.

1 Answers  

---

Describe the function of Accumulator into the Pump

0 Answers  

---

Please any one can explain how to calibrate transmitter (smart) online with out remove from the container suppose it is interface level or static pressure level measurement we dont want to remove transmitter from the container mean it is running plant please give me detail. thankx brothers

1 Answers   KNPC,

---

in which mode of the zener diode act when load voltage is approximately constant

1 Answers  

---

EXPLAIN NETWORK COMMUNICATION ON DCS?

0 Answers  

---