Q-1 what are the structural and operational difference between a distrib

Q-1 what are the structural and operational difference between a distribution and a power transformer?
Q-2 what is skew in motors?
Q-3 draw equivalent circuit of transformer
Q-4 explain with phasors how pf is improved with loading in induction motors
Q-5 DIFFERENT METHODS OF CABLE LAYING(interviewer asked if i heard new chemical based earthing system next)
Q-6 pi model of medium length trans line
Q-7 v/f control?why
Q-8 vacuum circuit breaker operates in?

Question Posted / guest

1 Answers
5354 Views
Vijai Electricals, I also Faced
E-Mail Answers

Q-1 what are the structural and operational difference between a distribution and a power tr..

Answer / guest

1. pwer distri
operational near full load charachs near no load
structural mostly delta delta delta star(neutral grounded).

2 .skewing is done on rotor to prevent magnetic locking btween rotor and stator also done to reduce noise and harmonics

3 4 6 .can be found on net
5. trays,direct burial in ground,trenches etc(next question followed on why petrochems dont use direct burial in ground tech-ans chemicals eat away insulation)

7.v proportional 4.44 phi f n
v n f only variables rest constant
if change v alone to higher value,to maintain constant flux f changes to lower value so ratio v/f is changed n not alone v or f

8.10^-6 to 10^-8 torr used mostly inremote area due to practically low maintain and high reliable

last question was important
Q- whats salary expectation

Is This Answer Correct ?

12 Yes

1 No

Post New Answer

More Electrical Engineering Interview Questions

what is the difference between bus-coupler and bus-riser

2 Answers

What is duty cycle for HT motors? How many start permitted if mentioned as 01 for hot and 02 for cold per duty cycle?

1 Answers GVK,

what is the difference between multimeter and megger?

3 Answers Bhel, Metro,

How to calculate no of EARTH PIT? Describe the formula as per IS standard?

0 Answers

In a parallel circuit dc circuit with two resistors, if you know the voltage, amperage, and one resistors ohms, what formula is used to find the second resistors ohms?

6 Answers

how many types of grounding?

7 Answers

WHAT IS THE DIFFERENCE BETWEEN RESISANTANCE AND IMPEDANCE IF IMPEDANCE IS MORE THAN RESISTANCE AT SAME VOLTAGE CAN WE HAVE RELATION DERIEVED BETWEEN THEM

4 Answers

Why can't we parallel Voltage transformer secondary circuits?

0 Answers

we have earthmat at 110KV substation.we would like to take earth resistance.b some says that by connecting earth megger terminals (C1,P1) at middile point of earthmat (at riser) will cause voltage gradient at other earthmat nods and dont get exat earth resistance.when connecting at end nods will get exat value . is it correct .please explain

0 Answers TNEB Tamil Nadu Electricity Board,

What will happened, if field voltage change with 220 voltage to 110 voltage for a dc shunt motor?

1 Answers

Can anybody tell me the Electrical IS rules website?

1 Answers

Can I use RCCB in moisture control device in a submersible pump.

2 Answers TATA,

For more Electrical Engineering Interview Questions Click Here