Answer / asheesh

we can apply rated voltage and assume power factor as 0.8
then
rated current = rated power/rated voltage*power factor

Answer / gunesh urs k

KA Rating can be calculated by simple Ohm's Law.

I = V/R,
[where R value is calculated by formula ρl/a, ρ=Resistivity
of material of conductor, l=Length of the cable & a=Cross
Sectional area]

Answer / abdul ghouse

Watts = Volts X Amps X p.f.

You can get the AMPS by the Measuring equipements/Meter.

You can take PF = 0.8,

(Power = Work done * Time) Units

Which motor has high Starting Torque and Staring current DC motor, Induction motor or Synchronous motor?

5 Answers   BSL, Elite, TTA,

---

Why GRR starts from 60% of motor speed why not less than 60%?

1 Answers  

---

how can service sitting be setted for MCCB?Example for sittings IR (CURRENT RATING),IS(CURRENT STARTING)IO (current operating)?

1 Answers   SISL,

---

In a company the lines carrying 33KV but the load is below 10000Volts so we know that <11KV we can put 11KV lines but the lines are 33KV,..so how we can step down the voltage to 11KV with out erecting a substation

1 Answers  

---

what is mean by hvdc transmission technology .what is principle of hvdc transmission and technic of hvddc transmission .

1 Answers  

---

Please help me regarding my one concern. - During earth pit testing we noticed that the Clean earth pit and dirty earth pit showing continuity (Resistance value - 5ohm) . I want to know that if both earth pit have separate location and there is not internal looping between PIT then why such continuity is showing on it . Because of this issue the field side all earthing point showing short. In PLC panel we are providing two types of earthing cable which is coming from separate earth pit (Clean and Dirty earth pit) because of earth PIT showing short our PLC is not complying spec . please help regarding this issues.

1 Answers  

---

in 1-phase 230v,how in 3-phase 440v. in each phase in between 230v.

1 Answers  

---

which plant has high load factor

10 Answers   APTransco,

---

What are the types of Bus bar?

8 Answers   CTEVT,

---

how to select a capacitor, i mean we use 3.5 mico ferad cap for a celling fan,but how to select a cap for 1h.p motor,etc.........

1 Answers  

---

why we are using large cross section cable at load side and small at other (11kv to trsfr)side of transformer? when the load increses current at both side increases,right?

2 Answers  

---

What is the rating of your capacitor bank at your company.

36 Answers   Ajnara Group, Amara Raja, Amol Electricals, Apollo, ATC, Bhagiradha Chemicals & Industries, Bharat, CBRE, Cisco, Government, JLL, MEIL, Reliance, Sterling, TNEB Tamil Nadu Electricity Board, Torrent Pharma, Victory,

---