Interested to Buy Any Domain ? << Click Here >> for more details...
how to calculate kA rating of device?
- 3 Answers
- 14194 Views
- Siemens, Vijai Electricals, I also Faced
- E-Mail Answers
Answer Posted / asheesh
we can apply rated voltage and assume power factor as 0.8
then
rated current = rated power/rated voltage*power factor
| Is This Answer Correct ? | 10 Yes | 2 No |
Post New Answer View All Answers
What is the capacity of the Fastners 12mm?
hi,every one, i have to write the search paper on "performance policy optimization" of NGN (next generation networks). i need the material on this topic. can any body help me. please tell me any useful site where the good material is available and name of any reference book. it should be a great help for me.
what is meant by brushed alternator & its working principle ?
what is two point starter?
what do u understand about FACTS? how they are useful?
how to find 5 kilo meter long under ground 33 kv cable fault location if IR VALUE shows 0.05 M ohm @5000 volt.and cable fault locator shows some time fault distance 3 kilo meter ,3.7 kilo meter and some time 1 kilo meter? now how to find the fault location that where is leakage. note--it is tested with 5000 kv megger and insulation resistance is 0.05 M ohm. and some time 0.03 M ohm comes.
How can we calculate the transformer rating if the load calculated is 1000KW (11Kv Supply)?
where can i get vijaya electricals limited in hyderabad interview auestions can u give me the website address plz
Why the power generated in dams is complex power? Why the generators in dams cannot produce Real power directly (i.e power which has zero reactive part)?
in the case of 6.6kv motor starter combination contain fuses on it VCB. but in 11KV motor starter combination Fuses are not using in it's VCB why?
If the line voltage is reduced to 75% of its rated value then by what percentage current will reduce ?? 75% 25% 50% no change and why ?
How much ph is maintained of water resistance starter for slipring induction motor ?
1 “earthing” for bonding of equipment and circuits to common plant earth electrode potential, 2 “protective earthing (PE)” when this bonding is required for personal safety provisions 3 “grounding” for interference suppressing bonding of screens, sys-tems with ground level 4. low-impedance earthing ? 5.primary earthing system and secondary earthing system what is that? 6.earthing electrode or mesh net earthing electrode ? very confusing , simple but very informative help required ? i will be very very thankful to you guys.
how to conduct dc resistance test for rotor of an alternator and how to measure the rotor dc resistance value theoritically?
Iin ESP why positive is grounded ? why not negative ?
