Answer / avinashkm

in remote start DG is directly started to rated speed.in this method we need external control pannel.


in manual start the DG starts at idle speed and then is transfred to rated speed
in manual starting we have to crank the key while in remote strat the key is needed to be only in run position.

Answer / s .karmakar

In remote start DG set we need a controller by which we can
send command to the dg set to start(by making a "NO"
contacrt "NC" ) depend on our requirment.

can i use 4 number of circuit breaker as single phase manual change over switch? if yes then how plz also send ckt diagram at nazimzamurad@gmail.com

0 Answers  

---

CAN WE GENERATE AC WITHOUT DC EXCITATION?

1 Answers  

---

TELL ME, WHERE SHALL I GET BASIC ELECTRICAL ENGINEERING BOOKS IN INTERNET?IT SHOULD CONTAIN ALL DEFINITIONS?

0 Answers   TCS,

---

What core magnetic balance test of transformer? How to do this test in a three phase Star delta (star-LV, Delta-HV) transformer? How to measure and where to measure? thanks and regards Austin

22 Answers   Neutech, Power Grid, TSSPDCL,

---

For Eg a 30 kw motor at full load how much kw it takes And at no load how much KW it will take?

1 Answers   GEPL,

---

how to setting Load amps tripping time and extra settings for load Transformer protection relay with RMU panel using C&S model relay..?

0 Answers  

---

What is the need of ISOLATION Transformer?

1 Answers  

---

how open delta PT works & what is its construction?

0 Answers  

---

When we giving the 3 phase supply to ups system how to coming netural?

0 Answers   Juniper Networks, Tata Motors,

---

I have a 1000 kVA Transformer(11kV/0.415kV) and a APFC panel of 400 kVAR(LT).Now if i want to remove the LT APFC panel and install a HT(11kV) APFC panel on the HT side is the HT APFC panel will work same as the LT APFC panel(improve the power factor),if yes what will be rating of the HT APFC panel?what is the formula to calculate HT APFC panel rating???

2 Answers  

---

Could anyone clarify my wondering. What is the difference between knee point voltage and saturation voltage of the CT. Is their any formula to calculate these values?

2 Answers  

---

pf of synchronius motor is unity, is it axact(=one) value. ?

1 Answers  

---