Answer / sidharth

It depends on condition in which you are operating it.

If you are operating it over excited and on no load condition then its power factor is greater than 1(this is used to used to improve power factor).

If it is operating in under excited condition then power factor is less than 1.(it will supply reactive power).

what is the cable capacity of any load wise .

2 Answers  

---

Why saturation region slowly shifted in the left side?

0 Answers  

---

in the thermal power plant, why we use the condenser (for cooling the steam) when we have to heat the steam again. i mean why we are cooling the steam,

6 Answers  

---

how will protect transformer agint overcurrent protection

6 Answers   MPSEB,

---

What are the different circuits in thermal power plant?

0 Answers  

---

what is per unit calculation?looking for simple and strong explanation thk u

0 Answers  

---

I have 725KVA DG set how to Calculate the Ratio of KWH? Whatb is the Formila

7 Answers   HCL,

---

Either the Armoured Earthing strip of HT 3 core cable have to pass through CB CT or not , why ???

0 Answers  

---

what is meant by frequency ?

10 Answers   TCS,

---

what are the disadvantages of leading P.F(power factor)?

2 Answers  

---

Is there any question in the name of Static Switch in UPS??

0 Answers  

---

We are preparing another project which involves Waste heat recovery from a 1 MW GE Engine. The Engine in particular gives out flue gas at 487Deg C with a flow rate of 5650 kg/hour and this can be cooled to 180 Deg C. This gives a thermal output of ~ 594 KW that is available for input to VAM via heat exchanger / boiler. Additionally 581 KW will be available from engine jacket water (temperature profile 80/ 80 Deg C and a flow rate of 50m3/hr) Our estimation is that 300 TR of cooling is possible with a suitable VAM machine(s). Please advise what is the most suitable arrangement with maximum TR and min Capital expenditure. plz reply me as early as possible

0 Answers  

---