pressure switch range 0 to 2bar.i have to install from ground level to 5 meter

pressure switch range 0 to 2bar.i have to install from
ground level to 5 meters height.what is the formula the to
increse the range ? and every 1 meter how much pressure
should be add ?

Question Posted / madhu144000

3 Answers
6559 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

pressure switch range 0 to 2bar.i have to install from ground level to 5 meters height.what is the..

Answer / rajkumar.diice

At first you
should know
clearly the
correct fluid
density. If you
are working with
water; the water
density is
1000kg/m3.
Multiply this
with the tank
height 5 meters
then the
pressure acting
on switch at
liquid level 5
mts will be
5000mmWC, set
switch setting
at .5 bars. If
you are looking
to switch a
motor off
automatically
means use NC
contact.

Is This Answer Correct ?

11 Yes

1 No

pressure switch range 0 to 2bar.i have to install from ground level to 5 meters height.what is the..

Answer / mrmk

It depends upon the tapping point.In your case if the
tapping point is at ground level and pressure switch
installed above ground level then no need of any
compensation.

Is This Answer Correct ?

2 Yes

0 No

pressure switch range 0 to 2bar.i have to install from ground level to 5 meters height.what is the..

Answer / mohsin malek

my ans is pressure is depend upon matrial density
supose water density is 1000kg/m3 multiply by tank hight

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

How addressable fire systems work? Pl. send details with architect.(Loop), also send details regarding Gas system. Pl. help me.Thanks

1 Answers Siemens,

How we will check whether the proximity, which we have is either NPN or PNP, if no data sheet or manual or any details is available to us ???

1 Answers

How to do calibration of magnetic flowmeter

1 Answers Kharafi National,

In turbine what does term CDP, NI, NH, HSSOC means.

1 Answers ADMA OPCO,

For crude application in floating roof tank, how to calibrate a DP Transmitter? How is the floating roof weight considered?

1 Answers

temptrure me ketne frequiency hote hai

0 Answers ME,

Make a ladder diagram on LSL valve will close, on PSL valve will open and start the motor

1 Answers CCIE,

Can anyone explain about ELectropneumatics principle?

1 Answers Forbes Marshall, Step,

what is difference between OP AMP and differential amplifier?

5 Answers TCS,

hi this is noor i wnt know the procedure and precations errection for PRESSURE AND DP transmitters? how to take impusle line for level and flow?(water and steam) impulse line sizes? and type of material ? plz give me answer / reffer any website ? to me "mail2noor.hyd@gmail.com"

1 Answers

why we set -10 volt in vibration sensor output,why not +10 volt

3 Answers GE, Honeywell, LLM,

Explain what is meant by the term “FLASH POINT” of liquid?

2 Answers

For more Instrumentation Interview Questions Click Here