Explain what is meant by the term “FLASH POINT” of liquid?

Question Posted / zoroskee

2 Answers
6338 Views
I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

Explain what is meant by the term “FLASH POINT” of liquid?..

Answer / abu zarrar qaisi

The minimum temperature at which a liquid gives of a
sufficient concentration to form an
ignitable mixture.

Is This Answer Correct ?

5 Yes

1 No

Explain what is meant by the term “FLASH POINT” of liquid?..

Answer / navneet jain

Flash point is that point it will be start of ignitation of any types of liquid.

Is This Answer Correct ?

0 Yes

0 No

Post New Answer

More Instrumentation Interview Questions

what is the difference about HART, and 4-20mA signal?

8 Answers

what is the procedure for auto tune in masoneialn 12300 series displacer type transmitter?

0 Answers

We Have Two Field bus Pressure Transmitters of Different Sensor Range (I.E One is of Lower range and Another is of Higher Range).Is same Process Line. My Question is Can i provide Saturation Limit to my field Bus Transmitter as We can provide Saturation current limit to HART Instruments. As During Low Pressure Both Working OK ,But During High Pressure, transmitter with Lower sensor range Goes to Fault mode as Beyond its Sensor Limit it can Measure, So may I provide Saturation point Some where to Suppress This Fault during High Pressure.

0 Answers OPaL,

i have level transmitter -400 to 0 range for steam drum application but i am unable to calibrate if installation of lt below lower tap what will be the effect ? and as per std wht is location of lt ,above lower tapping or below

1 Answers

open tank and close tank leavel transmiter about range and calibration

0 Answers

can u plz send me technical questions asked in SCHNEIDER ELECTRICAL technical paper?

0 Answers TCS,

How many problems can be occurring in solenoid valve? And how it can be rectified?

1 Answers Adgas,

1)How many tpes of vibration probe and how many tpyes of vibration. 2)how we can calibrate a vibration probe with tk3 3)what is RMS value in vibration measuring application and how we calculate it.

0 Answers

what is the difference between magnetic flow meter and mass flowmeter

0 Answers

is here anybody who knows how to calibrate the pressure transmitter? ONLINE

5 Answers

What is voltage regulator?

0 Answers

what is difference b/w the solinoid volve and autodrain?

3 Answers

For more Instrumentation Interview Questions Click Here