What is the Differance between Graphics And SCADA Graphics? SCADA Graphics hav

What is the Differance between Graphics And SCADA Graphics?
SCADA Graphics have less access?

Question Posted / shakalaka

3 Answers
9291 Views
Honeywell, Thermax, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

What is the Differance between Graphics And SCADA Graphics? SCADA Graphics have less access?..

Answer / aashish

Graphics is only for design of component and only for
visualisation but Scada graphics has connected with well
written program with the hardware.
If value provided it directly input into system such as in
plc. basically it is a graphics which executes command.

Is This Answer Correct ?

13 Yes

4 No

What is the Differance between Graphics And SCADA Graphics? SCADA Graphics have less access?..

Answer / shakalaka

Not Satisfied by this answer.. Can any one tell me in brief?

Is This Answer Correct ?

2 Yes

1 No

What is the Differance between Graphics And SCADA Graphics? SCADA Graphics have less access?..

Answer / abdus sattar mollah

SCADA Graphics are based upon,on and for REAL TIME DATA unlike Graphics.

Is This Answer Correct ?

1 Yes

3 No

Post New Answer

More Instrumentation Interview Questions

when the force applied on load cell the ohms will be varriying .and how its convert ohms to mv generate and have any formulae?

1 Answers UETCL Uganda Electricity Transmission Company Limited,

If i have 4 Allen Bradely make RS logix 5000 PLC and for viewing that we are using 4 RS view SCADA for 4 different packages. Now, I will want to view two packages on only one SCADA. Then how i will do it?

0 Answers Essar, Reliance,

How to calibrate Magnetic flow Transmitter in Field

0 Answers

Difference between 2-Valve Manifolds, 3-Valve Manifolds and 5-Valve Manifolds 3 with diagram

0 Answers Acire Systems,

what master plc do?

2 Answers ISRO, Yokogawa,

What is zone,loop/fire alarm system?

0 Answers Emco,

in my company organisation in plan to take new PLC system for replacing old relay system , for that what I/P needsd to submit to the system house of PLC supplier?

1 Answers

Why ac supply load cell is used? Can we use the dc supply load cell?

0 Answers

i have calibrate rosemount make level transmitter , wht can i do ? my tank capacity is 30,000 liter

9 Answers Equate,

Calculate the maximum pressure drop that can be allowed to occur across a control valve, so that we can prevent cavitation / flashing from occurring. Use the following formula: Δ P allow = Km (P1 – PvapourA) where, Δ P allow - the maximum allowable differential pressure for sizing purposes, or terminal pressure drop; Km- the valve recovery coefficient from the manufacturer’s catalogue; P1 - absolute inlet fluid pressure; PvapourA - absolute fluid vapour pressure at the inlet temperature; Use Atmospheric pressure = 101.3 kPa, P1 = 1200 kPa(g), PvapourA = 4 kPa, KM = 0.72

0 Answers

What is DCS?

4 Answers GAIL, Sabic, Trident, Yokogawa,

can we replace a pressure transmitter of range 0 to 25 Kg/cm2 by a Pressure transmitter of range 0 to 10 Kg/cm2 ?.. Will it affect 4 to 20 mA output signal which we will feed to the PLC.

9 Answers IOCL,

For more Instrumentation Interview Questions Click Here