Answer / ramya

yes the current will differ since the load applied and
voltage are same the single phase consumes more current
than 3phase anh hence the losses are high in single phase
than 3 phase system

Answer / shyamkr

i think that current will depend on star or delta
configuration of load.when it is star connected line current
=phase current so in this case current will remain same as
in single phase,while when load is delta connected current
will become /sqrt 3 times the line current and current will
vary in that case.

Answer / monika hassan.

Yes, the current will differ in both the cases.

Answer / monika hassan.

Because in single phase P =V*I and in 3 Phase P=√3*V*I.
current depends on voltage.

Answer / pranav

I think current will depend on star-delta of 3phase and due
to that Vph will vary and in accordance current will vary.....

1. How many types of mangers? 2.How many types of capacitors? 3.pls tell me normally types alternator problems?

0 Answers   APCPDCL, Voith,

directional relay is typically used to respond in fault condition who it can be used just as reverse power protection which purely senes direction reversal to operate a circuit breaker?

1 Answers  

What happen if the 24 volt DC supply is disconnected from air circuit breake ?

2 Answers  

according to faraday's law whether the induced emf is average or rms value?

2 Answers   Power Grid,

how can we select the appropriate VCB ?

0 Answers   Reliance,

why ht11kv supply needs discharging during shut down time

1 Answers  

Distinguish between neutral earthing and equipment earthing?

7 Answers  

how much cuurrent flow through human body effected ????

7 Answers   Divis Laboratories, ICSA,

What is the function of neutral CT in transformer? Turn ratio of typical CT for 2MVA transformer ? or relation between full load current of transformer and neutral CT ?

1 Answers   Electrical Inspectorate,

why HT wire making noise?

3 Answers  

what is Princepale of Transformer Taps.

1 Answers  

In UPS what does 600va reffer to?

4 Answers