Interested to Buy Any Domain ? << Click Here >> for more details...
considering the 3phase and single phase ac system the load
applied and the volage given is same...will the current
differs for both the cases are it wil remain same?
- 5 Answers
- 6982 Views
- I also Faced
- E-Mail Answers
Answer Posted / shyamkr
i think that current will depend on star or delta
configuration of load.when it is star connected line current
=phase current so in this case current will remain same as
in single phase,while when load is delta connected current
will become /sqrt 3 times the line current and current will
vary in that case.
| Is This Answer Correct ? | 1 Yes | 0 No |
Post New Answer View All Answers
A 400 V, 50 Hz, Δ connected synchronous generator has a field reactance of 0.1 Ω and armature resistance of 0.015 Ω. At full load, the machine supplies 1200 A at 0.8 pf lagging. Under full-load conditions, the friction and windage losses are 40 KW and the core losses are 30 KW. What is the machine’s overall efficiency? Ignore any field circuit losses.
what is the use of expulsition protective gap in 11Kv line.
what is strip power factor?
Why is better to have a minimum ceiling voltage of 250% than 160%?
what happen when increase or decrease size of lamp,light.glass.
What is the difference between solid grounding and impedance grounding?
Apparent power is expressed as V * I(Conjugate). Why not in V * I ?
WHat is the general checks required for Dry type transformers
how to find motors H.P. whout any rating? (only give you a motor and multimeter)
Why Utility Distribution System in India is mainly at 11 kV? Why not Utility go for 33 kV?
what material is used in capaciter
Salient pole alternator is more stable, why?
What is meant by control system?
in cvt,there are two windings,1a,1n and 2a,2n.in my one project i use only one winding i.e.1a,1n. the other winding is not in use, so i connect it in open delta and want to close it by ibsertibg thermal resistor. the output of cvt is 132kv/115/sqrt3. plesae tell me exact value of resistor, so i may close it to avoid the resonance phenomenin. send me answer on this email adress please. aetcon-po@aetcon.com
To prove the capacity of a 10MVA transforemr with 6.5% impedance by a short circuit test how much power is needed to inject an impedance voltage if we have to arrive for its rated current?
