Answer / mani0786

its half wire series connection & phase sequence

Answer / suga priya

simple multimeter is used to check for failure. The coil can become shorted, grounded, or open. The coil can become shorted when the insulation between the wires in the coil breaks down. This can be found by shutting off the power and taking a resistance reading between the terminals on the coil. The reading should be around 20 ohms, if it is significantly less, the contactor should be replaced

How is a capacitor bank is designed ?

2 Answers   Asian Paints,

---

Why derating factor os applied on Cables?

0 Answers  

---

The formular of how to calculate a cross sectional cable to feed an electric motor. Examle: 15KW, 26.1A, 415V. Calculate the cable size in mm2

3 Answers   Sona,

---

What are the saftey parameters in transformers?

2 Answers  

---

What is the normal value of delta in rotor angle stability or transient stability? Why it selected so?

1 Answers  

---

what is meant by class 1 E in electrical power supply?

0 Answers  

---

If ac voltage applied to the field of dc generrator the output of dc generator ?

1 Answers   SSC,

---

What is the function of under voltage release ?

0 Answers  

---

what is difference between cpp electrical system and refinery electrical system

0 Answers  

---

stand by earth fault protection (51G) for transformer rating 2000 kVA,Dyn11,33/0.400 V. LV NCT ratio and necessary resistor and metrosil values how to calculate

0 Answers  

---

what is the max. acceptable leakage current in 33kv bus bar

0 Answers   Tanesco,

---

what is power factor ?

3 Answers  

---