Answer / saravanan.p

Due to single phase, the fan will not rotate. The capacitor
is having leading power factor.That is +90 degree leading
from phase voltage.

Due to capacitor, The single phase splits into two phases.
This phase difference use to stimulate the fan to rotate.

Answer / mahesh goud

slipt the phese
due to single phase motor not self start

Answer / arunava

It simply splits the phase angle like a two phase system,
during startup.

Answer / shailesh singh

Single phase motor are not self starting for this we
produce phase split between voltage and current by using
capacitor

Answer / ghaniullah khan

Ac supply given to a equipment having winding then there is a lagging power factor then we use a capacitor which has leading power factor then voltage and current are in phase into some extent which increase power factor.

Answer / mallikarjuna reddy

usually fan having two types of windings,i.e starting wdg &
Running wdg.
whenever we switch on the supply the fan may take the
moment slowly due to starting wdg,at this time fan requires
some reactive power(because fan wdg acts as inductive
load),at this time capacitor supplies this reactive
power.then only the fan will rotates with its own RPM.

Answer / prathamesh

For increasing power factor.

Answer / mousumi

AT STARTING CONDITION CAPACITOR PRODUCE TORK. IN RUNNING
CONDITION CAPACITOR IS ALSO WORK FOR RUNNING PURPOSE.

what is cogging and crawling

0 Answers   Suzlon,

Define what is power quality meter ?

0 Answers  

Explain Need of a starter in a dc motor.? Also explain any two starting and speed control method of dc motor?

0 Answers  

Is the theorem applicable to ac sources?

0 Answers  

Why it is necessary to isolate fire fighting when you are taking shutdown for lv board.

0 Answers   KSEB, L&T, Siemens,

Impedance relay is directional relay or non directional relay?

2 Answers   KSEB, NTDC,

A 500 V shunt motor runs at its normal speed of 250rpm when the armature current is 200A. The resistance of the armature is 0.12 Ω. Calculate the speed when a resistance is inserted in the field reducing the shunt field to 80% of normal value and the armature current is 100A.

0 Answers   VECL,

How is efficiency of DG set calculated? At many places I found the efficiency to be mentioned in percentage. But at some other places I found kWH/ litres. I want to know how dimensionless percentage value is arrived at?

0 Answers   ADS Spirits,

Can u explain : how capacitor act when the supply is given is a.c and d.c. I know that when d.c supply is given then the capacitor charges and becomes open circuited. But please say about when a.c is given. I have seen that when a.c supply is given ,it charges and discharges, But when we plug in capacitor to our daily supply and take it out ,then we join those wires spark will appear,which seems charge is present ,but when a.c is given it should charge and discharge

3 Answers  

What is effect of over voltage and under voltage on ACB

0 Answers   EFS,

Why short circuit calculation is not required in LT cable sizing and requiredin HT cable sizing only

2 Answers   Chemtex,

What should be ideal IR value for 11kV, un earthed, 1 MW motor?

3 Answers   Sail,