what is the rating of boiler?
Answers were Sorted based on User's Feedback
Answer / chetan
always boiler rating specificy in ton per hour.
Is This Answer Correct ? | 15 Yes | 2 No |
Answer / p.muralikrishna
The amount of steam in Tons per hour at a pre-determined
temperature and pre-determined pressure along with blow down
allowance is rating of a boiler.
Is This Answer Correct ? | 4 Yes | 3 No |
what is compatible kva for 3300 watts and why
IC 741 is opampIC..moreover AND OR NOT ICs also have '74' in them.. why is that number specifically used?
respected sir, sir recentely i have applied for chennai and tiruvananthapur section enggineer and juniour engg in electrical dept. but still i donot get how i have to syart my preparation and also t the same time i donot know exactly what they r going to give in the examinations i mean which sections they r going to give i donot know exactly, can u prefer whichh books i have to follow and model papers or both boards
What is the need of earthing transformer for delta side of a transformer. (Think of a line section between a star/delta transformer at a grid substation and delta/star transformer at a village. An earthing transformer is there at the delta side of the star/delta transformer at grid substation). As there are no ground reference there will not be fault current if a one phase is grounded. Further L-L phase will be sensed by the primary side of star/delta transformer as a L-G fault. So why an earthing transformer is required at delta side
What happens when generator is running with leading power factor on it say -0.96. what are the effects of it on alternator and the other generators operating in parallel to it.
What is the role of ESP(Electro Static Precipitator)in steam power plants? Where it is located? How it works?
what is the working of air drayar
Pole of s-plane gives the information about?
what is the pressure of vacuum circuit breaker
In the solution of load flow eqation, Newton raphson method is superior to the gauss siedal method because (a)the time taken to perform one iteration in the NR method is less when compared to GS method (b)the number of iterations required in the NR method is more compared to that in the GS method (c)the number of iterations required is dependant on the size of the system in the NR method (d)convergence characteristics of the NR mehod are not affected by the selection of the slack bus
why we used.c source in the field of the alternator , why not a.c source.
why in an electrical lab a bulb connected to supply goes off slowly when the main supply is switched off?