what will happen if field winding supply of synch generator
accidently got disconnected?
Answers were Sorted based on User's Feedback
Answer / ibrahim
if field supply got tripped generator behaves as an
induction generator
| Is This Answer Correct ? | 1 Yes | 0 No |
if field winding is disconnected then generator is not
build up bcz there is no any flux in the air gap so no flux
will be cut by armature conductor and at the same time no
emf will be induced
i think raghavendram wrong bcz obove condition occur when
prime mover is disconnected and excitation remains on..
| Is This Answer Correct ? | 1 Yes | 0 No |
Answer / pankaj agarwal
there are two scenarios one in which it is running in
islanding and other in which it is interconnected with
other system. in case one as field is cut there will be no
supply of exciting current and terminal voltage will fall
to zero. also turbine will tend to overrun as there is
sudden removal of load.
in case two as it is interconnected the stator is still
excited and it will behave like induction generator.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / raghavendran
If Dc Excitation to the field winding got tripped, then a
condition occurs where the syn. gen draws power from the
grid and starts behavingas a motor.Though this condition is
not allowed to persist, and the system is isolated from the
grid.
| Is This Answer Correct ? | 1 Yes | 2 No |
1.what to do if ferquency of any power system continue to decrease ?
How to know motor winding is star or delta connected without see the information table and winding connection ?
Why secondary of a CT in a power system acts as an open circuit after core saturation?
What is Tan Delta Test
Differnce between Analog & Digital
what is the disadvantage if earth is connected to neutral
suppose there is afault in transmission line connected to a generating station, then what r the adjustments u will take to without loss of synchronism?????
The efficiency figures for energy efficient motors (in comparison with standard efficiency motor) can be generally higher by____%.
WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?
Zone of protection and tripping scheme of arc protection relay.
why do we use UPF watt meter in short circuit test of the transformer and LPF watt meter in open circuit test of the transformer
how load of a turbo generator can be increased
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)