WHAT IS THE WORKING PRINCIPLE OF A GENERATER.how is a GTG (Gas TURBANE Generater) working.plz explane

0 Answers   Assure Group,

---

Whether capacitor loads can be connected for testing a diesel engine at its full load capacity? Is there any limitation of capacotir load? Which is the best load for testing DG sets?

2 Answers  

---

For 1 KVA load how much KVARH capacitor can be used ?

3 Answers   NLC, TNEB Tamil Nadu Electricity Board,

---

why we use condenser in the thermal power plant, althrough the same vapour will be again heated

0 Answers   Bhel,

---

110 KW MOTER DOL STATER 240SQ.MM CABLE MOTER AND STARTER DISTANCE IS 110 METER WHAT IS VOTAGE IN MOTER END AND SYSTEM VOTAGE IS 415 V HOW I CAN CALCULTE

2 Answers  

---

If Three Runs of 1Cx300 Sqmm Cable between Transformer and VCB and the distance between 100mtrs. what will be total length of Cable and if cost 1500Rs per meter,what would be the total cost

1 Answers   ANITS,

---

plz send me Bhel, Mahagenco, sbi previous exam paper for electrical engineer on my email-id kambali_smita@yahoo.co.in

0 Answers   Bhel,

---

how much value of resistance should connect to 15 kw, 6 pole 3 phase slip ring induction motor having RV-240, RA-42.

0 Answers  

---

when i am going to take trail on a 3ph sq.i/m motor 5.5kw, i observed that RPM of the motor is very low as compared to the rated RPM and also it rotates in clockwise in first ON command,and anticlock wise in second ON command. finally i observed that on phase is no available . but iam not clear about, why the motor is rotates in both directions without any phase interchanging.pls answer to my question.

1 Answers  

---

why capacitor bank is not used in generator power

7 Answers   Caterpillar,

---

how to connect generators in parallel and what are the required equipment to do so?

2 Answers   MSEB,

---

why is corona loss greater in a stranded conductor as compared to a solid conductor ?

2 Answers  

---