WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?

Categories >> Engineering >> Electrical Engineering
Suggest New Category

WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN
DISTRIBUTION LINES?

Question Posted / r.venkateshwaran

6 Answers
9135 Views
Bhel, I also Faced
E-Mail Answers

Answers were Sorted based on User's Feedback

WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?..

Answer / v.senthilkumar

In high voltage Sub station, LA to be placed at transformer
end and input line end to protect our incoming line,
Substation equipments and transformer.

Is This Answer Correct ?

10 Yes

0 No

WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?..

Answer / santosh maske

L.A placed below and IIrl to Distribution Line.

Is This Answer Correct ?

3 Yes

1 No

WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?..

Answer / felixraj

in distribution s/m poles height was not more.LA at tfr end
mainly to protect tfr winding and sub-station equpiment

Is This Answer Correct ?

2 Yes

2 No

WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?..

Answer / gunasekaran

1.transformer incomer.
2.transformer bushing like horn type.

Is This Answer Correct ?

0 Yes

1 No

WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?..

Answer / vino raju

LA is mainly protect the substation equipment from high
impedemce voltage and also the first equipment inthe
substation is LA

Is This Answer Correct ?

0 Yes

1 No

WHERE IS THE LIGHTING ARRESTER SHOULD BE PLACED IN DISTRIBUTION LINES?..

Answer / sachin lakhe

At the start of Electrical line I mean at Power transformer.

and at the top tower if used towers.

last tower or poles top part.

Is This Answer Correct ?

0 Yes

2 No

Post New Answer

More Electrical Engineering Interview Questions

In case of salient pole alternator when number of poles are 4 or more than 4 it helps the flux wave to be sinusoid as air gap length is increased from center to tip , but if the number of poles are 2 how does the flux wave is sinusoidal?

0 Answers

HOW TO FIND OUT 1. LINE CURRENT, 2. PHASE CURRENT IN AN ALTERNATOR / TRANSFORMER WHICH IS FEEDING A I)STAR LOAD ii) DELTA LOAD, USING A CLAMP METER. NORMALLY WHEN WE USE CLAMP METER IN A DG SET THEN WHAT DO WE GET?? PHASE CURRENT OR LINE CURRENT.

13 Answers Bhel,

What is diversity factor and how to calculate it

2 Answers Al Faraa, Amul, Pentagon, Sobha Developers,

Which loss in DC machine is maximum?

1 Answers IFFCO,

what is the use of neutral displacement relay

1 Answers OCL,

what will happen if i connect or change line with phase terminal

1 Answers

Why synchronous motor runs at a fixed speed? what is the name of that fixed speed?

4 Answers

1.wat is the negative slip region in the motor?

1 Answers

why we permissive overreach in distance protection.where it is applicable to use in long r short lines

0 Answers

what will happen if one of the phases from a 3-phase motor is disconnected?? stop/run at 2/3rd speed or run at same speed????

3 Answers

what is meant by oil filled power & distrubution transformer ? if anybody know the link of detail about above transformers means plz send it i have interview on this week ? plz help me

3 Answers

why are we using multiples of 11 in substation.

2 Answers

For more Electrical Engineering Interview Questions Click Here