why is power supplied in 3 phase only? why not in 2 or 4
phases?
Answers were Sorted based on User's Feedback
Is there any option to replace two Genset of capacity 125KVA with one higher capacity for same office?
how we have to calculate the short circuit current for 33/11kv 2mva, 7.5% Z, Transformer primary side breaker and secondary side breaker short circuit current for both sides?.
Explain the function and difference of Restricted earth fault, simple earth fault and sensitive earth fault with connection diagram.
Which thing is maximum in RLC circuit at resonance a)power consumption b)inductive current c)capacitive voltage
what will happen if ac motor given dc supply?
What are the causes for the failures of sandwich type (Al) busducts?
what is the difference between earthing and unearth
how oltc works in rectiformers of higher rating (27 mva,200v dc,120kamps) please provide me full information with diaggram.
Is a contactor (or master relay) required between incoming lines and a VFD? The question goes to safety. If a contactor were used before the VFD and an e-stop engaged then the motor will coast to a stop (i.e. VFD loses power) instead of stopping much faster if the VFD braking fucntion were used. It would make more sense to keep power on the VFD.
explain why tap changer is always connected to high voltage winding side of the transformer.
sir, Two different rating of generator going to connect parallel, can it set same DROOP or different. Why? Please explain
opkinson's test
Civil Engineering (5086)
Mechanical Engineering (4453)
Electrical Engineering (16638)
Electronics Communications (3918)
Chemical Engineering (1095)
Aeronautical Engineering (239)
Bio Engineering (96)
Metallurgy (361)
Industrial Engineering (259)
Instrumentation (3014)
Automobile Engineering (332)
Mechatronics Engineering (97)
Marine Engineering (124)
Power Plant Engineering (172)
Textile Engineering (575)
Production Engineering (25)
Satellite Systems Engineering (106)
Engineering AllOther (1379)