Answer / vedpraksh uppadhaya

power tranformer are used at substation & they have maximam
efficency at full load .
power transformers have high ratting like wise 5 mva, 8
mva,...
these are used in 66kv , 33kv.
while the distribution have less efficency at full load as
compair to power transformer as well as their is no need of
controlling equipment like as bucollz relay. these are used
for distribution purpose example.500kkva...

Answer / rsundareee

The major difference B/W Ptr and DTr ,
* The power trans is step down and step up the High voltage
(HV-3Phase to 3Phase system)-for substation purpose
* The power trans have rating up to 500mVA(up to 400kV)
* The Distribution trans is step down voltage(HV to LV
Side -3Phase to 3Phase 4 wire system)-for domestic consumer
* The power trans have rating up to 50mVA(33,22,11kV to
0.415kV

Answer / amitsinh atalia

Power transformers have ratings above 500 kva and have
maximum efficiency at full load and are designed for higher
leakage reactance.
while distribution tranformers have ratings below 500 kva
and are designed for max. efiiciency at a load much below
than the full load, and should have lower leakage reactance.

Answer / neeraj pandey

I agreed with Mr. Amitsinh Atalia, but a correction is needed.
Generally Power transformers have rating above 5000KVA(not
500 KVA).
and Distribution Transsformers having rating Below 5000 KVA.

Rest is same.

Answer / shubham

apart from above written differences. the major difference
b/w poer and distribution transformer is that power Xmer is
Step up Xmer and distribution Xmer is step down Xmer

give me list of material for wiring of 20hp motor?

2 Answers   Alchemist,

What is the difference between ARC & SPARK?

4 Answers   OPTCL,

what is the maximum genarating in india?

17 Answers  

Hello sir This is prakash from bangalore i have a doubt why we have to maintain DG power factor in the range 0.78 to 0.8 Perhaps i f it is increased means what will happen in DG

3 Answers  

What is a roll of adopter panel in terms of h.t. Panel ???

1 Answers  

There are different classes of protections in power plants.class a,b,c are clear..is there any class d and e r there..and elaborate class b protection.

0 Answers   GMR,

Which of the following connection is best suited for 3-ph, 4 wire system A delta-delta B star-star C delta-star D star-delta

2 Answers  

What loads the lagging and leading effects comes in a circuit?

5 Answers  

What current position are you holding in your current company?

0 Answers  

could i arrange a faulty and healthey battery bank togather in parallel , if your ans is not then why?

3 Answers  

Why Motors are generally supplied with 3 core cables??? why not 4C??

5 Answers  

what is the lightning arrester rating for 3.3kv system voltage

1 Answers