Answer / e.subhash

The generator current goes to higher compare to same load and lagging power factor.
i observed while running generator

1.Difference between vcb and Acb and partes. 2.Difference between STS and ATS.

2 Answers  

---

We have two Al.busbars each of size 125mm*10 mm connected in parallel.To increase the current rating ,can we connect third busbar of size 100mm*10mm in parallel to existing two busbars?In my opinion ,if we connect busbars of different sizes in parallel,then the busbar of lowest size will take much current.So this type of paralleling should be avoided .Am I correct?

1 Answers   PDP Steel,

---

Sir pl provide 5 year sample paper for post junior engineer(electrical).I have currently applied for junior engineer (electrical) on RRB Ajmer

0 Answers  

---

What is the actual meaning of thermal power efficiency ?

0 Answers  

---

if dc motor can operate by ac supply ? if its possible means how ?

2 Answers  

---

i wasted one year for the job after completed my btech what can i say about 1year time in interview

0 Answers   Infotech,

---

is the value of inductance depends upon the evalue of thitha in doubly excited machine?

0 Answers  

---

Whay you want to change your job.

1 Answers  

---

how hydrogen cooled alternator undergo maintanence ? that is hydrogen when come in contact with air can result into explosions .

0 Answers   DVC,

---

25 kvar capacitor , how much current ? For 25 KVAR--Capacitor I = ?

3 Answers  

---

In power transmission using open belts or horizontal shafts it is preferable to have the slack side of the belt on the top because

0 Answers   Caterpillar,

---

I have 480V Single phase and I am trying to figure how big of a transformer (KVA's) and Primary breaker size I need to provide 200 Amps at 240V for a building.

1 Answers   Wipro,

---